CBC3112-D7C Cymbet Corporation, CBC3112-D7C Datasheet - Page 13

• Manufacturer Part Number: CBC3112-D7C
• Description: IC BATT SOLID ST ENERCHIP 20DFN
• Manufacturer: Cymbet Corporation
• Series: EnerChip™ CCr
• Type: Thin Filmr

Specifications of CBC3112-D7C

• Capacity: 12µAh
• Voltage - Output: 3.3V
• Operating Temperature: -20°C ~ 70°C
• Package / Case: 20-DFN
• Battery Size: 7 mm x 7 mm
• Length: 7 mm
• Rechargeable/non-rechargeable: Rechargeable
• Width: 7 mm
• Output Voltage: 3.6 V
• Termination Style: Solder
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 859-1006-5; CBC3112-D9C

EnerChip CC CBC3112 PCB Layout Guidelines - Important Notice!
There are several PCB layout considerations that must be taken into account when using the CBC3112:
1.
2.
3.
4.
5.
6.
7.
8.
DS-72-04 Rev B
All capacitors should be placed as close as possible to the EnerChip CC. The flying capacitor connections
must be as short as possible and routed on the same layer the EnerChip CC is placed.
Power connections should be routed on the layer the EnerChip CC is placed.
A ground (GND) plane in the PCB should be used for optimal performance of the EnerChip CC.
Very low parasitic leakage currents from the V
in unexpected drain of charge from the integrated power source. Maintain sufficient spacing of traces and
vias from the V
currents that can arise from solder flux or contaminants on the PCB.
Pin 1 V
There should be no traces, vias or connections under the CBC3112 exposed die pad.
When placing a silk screen on the PCB around the perimeter of the package, place the silk screen outside
of the package and all metal pads. Failure to observe this precaution can result in package cracking during
solder reflow due to the silk screen material interfering with the solder solidification process during cooling.
See Figure 12 for location and dimensions of metal pad placement on the PCB.
Figure 12: Recommend PCB Layout for the CBC3112-D7C Package (Dimensions in mm)
BAT
and Pin 4 V
©2009-2010 Cymbet Corporation • Tel: [phone] • www.cymbet.com
BAT
pin and any traces connected to the V
CHG
must be tied together for proper operation.
BAT
pin to power, signal, and ground connections, can result
BAT
pin in order to eliminate parasitic leakage
EnerChip CC CBC3112
Page 13 of 15