LDP10WH10-A Panduit Corp, LDP10WH10-A Datasheet - Page 138

• Manufacturer Part Number: LDP10WH10-A
• Description: RACEWAY 1CHAN LG AD WH(10=10')
• Manufacturer: Panduit Corp
• Series: Pan-Way™r

Specifications of LDP10WH10-A

• Wire Duct Type: Solid (Raceway), Single Channel
• Height: 0.860" (21.80mm)
• Length: 10.00' (3.05m)
• Width: 1.51" (38.4mm)
• Mounting Type: Adhesive
• Features: Attached Latching Lid
• Color: White

Faceplates,
Furniture
LD Profile
Overview
Selection
Technical
Ultimate
Labeling
Twin-70
Glossary
Boxes &
System
System
Office
Outlet
Quick
Guide
TG-70
Index
Cove
T130
T-70
T-45
Pole
Info
ID
&
&
N10
The marks found on PANDUIT
have been evaluated in accordance with the UL 5C standard. Our systems meet or exceed the requirements of
ALL (not just some) of the tests outlined. This assures the end user of a quality product, which will perform in a
safe manner when installed as recommended.
A product bearing UL 5C complies with the following:
• Utilizes a UL RECOGNIZED material with specific properties such as heat deflection temperature and flame
• FLAMMABILITY: The system materials have flammability rating of V-0. Both the raceway and associated
• IMPACT AT 23ºC: A 1.18lb steel sphere is dropped from a height of 51 inches to product an impact of 5 ft.-lbs.
• CRUSH: Both raceway and fittings are subjected to a compressive load of 100 lbs., which is maintained for
• MOLD STRESS: During the cooling process, stresses may be frozen in the raceway or fitting. This test
• TRIAL INSTALLATION: This is conducted to verify that the recommended installation instructions and
• SECURITY OF KNOCKOUT AND BREAKAWAY TABS: A knockout or breakaway tab shall remain intact
• HINGE CYCLING: A one foot length of raceway is mounted per instruction sheet. The raceway is then opened
NOTE: The information provided above is intended for use only as a guideline. Please refer to the specified document for detailed test descriptions or
standards information.
Order number of pieces required, in multiples of Standard Package Quantity.
class rating.
fittings exhibit self-extinguishing characteristics.
This test simulates the impact resistance of the product.
one minute. Following the removal of the load, both the raceway and fittings must remain intact.
conditions the product in an air-circulating oven for seven (7) hours at 70°C. After cooling to room temperature
the raceway system with cover must remain intact and secure.
mounting hardware are effective and that the system maintains a complete and safe enclosure of conductors.
following a force application of 10 lbs. for 60 seconds. Following the removal of a tab, no sharp edges shall
be left which could cause abrasion of the conductor insulation. This test assures that the tab can resist an
applied force but can be removed easily per recommended instructions.
90 degrees from its initial position and closed without latched for 20 cycles. The hinge shall have no functional
damage. This assures a safe lifetime of intended use.
(Standard for Surface Raceways and Fittings for use with Data Signal and Control)
®
non-metallic surface raceway systems assures that the raceway components
UL 5C Performance Requirements
Prime items appear in BOLD.