MD2534-D1G-X-P SanDisk, MD2534-D1G-X-P Datasheet - Page 56

• Manufacturer Part Number: MD2534-D1G-X-P
• Description: IC MDOC H3 1GB FBGA
• Manufacturer: SanDisk

Specifications of MD2534-D1G-X-P

• Format - Memory: FLASH
• Memory Type: FLASH - Nand
• Memory Size: 1G (128M x 8)
• Interface: Parallel
• Voltage - Supply: 1.65 V ~ 1.95 V, 2.5 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 115-TFBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Speed: -
• Lead Free Status / Rohs Status: Supplier Unconfirmed

9.3
mDOC H3 uses a NOR-like interface that can easily be connected to any microprocessor bus.
With a standard interface, it requires 16 address lines, 16 data lines and basic memory control
signals (CE#, OE#, WE#), as shown in Figure 11 below. Typically, mDOC H3 can be mapped to
any free 128KB memory space (8KB address space requires less address lines).
Notes: 1. The 0.1 uF and the 10 nF low-inductance, high-frequency capacitors must be attached
56
For power connectivity please refer to mDOC H3 power supply connectivity in section 9.5.
Standard NOR-Like Interface
2. The 1 uF capacitors are for internal voltage regulators stability.
3. mDOC H3 is an edge-sensitive device. CE#, OE#, and WE# should be properly
to each of the device’s power and VSS balls according to the above figure. These
capacitors must be placed as close as possible to the package leads.
terminated (according to board layout, serial parallel or both terminations) to avoid
signal ringing.
Figure 11: Standard System Interface
Data Sheet (Preliminary) Rev. 0.2
mDOC H3 Embedded Flash Drive
92-DS-1205-10