TC58FVM7T5BTG65 Toshiba, TC58FVM7T5BTG65 Datasheet - Page 14

• Manufacturer Part Number: TC58FVM7T5BTG65
• Description: IC FLASH 128MBIT 65NS 56TSOP
• Manufacturer: Toshiba

Specifications of TC58FVM7T5BTG65

• Format - Memory: FLASH
• Memory Type: FLASH - Nor
• Memory Size: 128M (16Mx8, 8Mx16)
• Speed: 65ns
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 56-TSOP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

10.17. Erase Suspend/Erase Resume Modes
Suspend command is allowed during an auto block erase operation but is ignored in all other oreration modes. When the
command is input, the address of the bank on which Erase is being performed must be specified.
and a Resume command. If an Erase Suspend command is input during an Auto Block Erase, the device will enter Erase
Suspend Read Mode after t
Sequence flag. If data is read consecutively from the block selected for Auto Block Erase, the DQ2 output will toggle and the
DQ6 output will stop toggling and
for the Auto Block Erase. Data is written in the usual manner.
which the Write was being performed must be specified. On receiving an Erase Resume command, the device returns to the
state it was in when the Erase Suspend command was input. If an Erase Suspend command is input during the Erase Hold
Time, the device will return to the state it was in at the start of the Erase Hold Time. At this time more blocks can be specified
for erasing. If an Erase Resume command is input during an Auto Block Erase, Erase resumes. At this time toggle output of
DQ6 resumes and 0 is output on
Erase Suspend Mode suspends Auto Block Erase and reads data from or writes data to an unselected block. The Erase
In Erase Suspend Mode, it is invalid except a Read command, a ID Read command, a CFI command, a Program command,
Inputting a Write command during an Erase Suspend enables a Write to be performed to a block which has not been selected
To resume the Auto Block Erase, input an Erase Resume command. On input of the command, the address of the bank on
SUSE
. The device status (Erase Suspend Read Mode) can be verified by checking the Hardware
RY
RY
/
BY
/
BY
.
will be set to High-Impedance.
TC58FVM7(T/B)5B(TG/XG)65
2006-05-10 14/88