AT29C010A-15TI Atmel, AT29C010A-15TI Datasheet - Page 3
![IC FLASH 1MBIT 150NS 32TSOP](/photos/7/21/72186/313-32-tsop_sml.jpg)
AT29C010A-15TI
Manufacturer Part Number
AT29C010A-15TI
Description
IC FLASH 1MBIT 150NS 32TSOP
Manufacturer
Atmel
Datasheet
1.AT29C010A-70JU.pdf
(18 pages)
Specifications of AT29C010A-15TI
Format - Memory
FLASH
Memory Type
FLASH
Memory Size
1M (128K x 8)
Speed
150ns
Interface
Parallel
Voltage - Supply
4.5 V ~ 5.5 V
Operating Temperature
-40°C ~ 85°C
Package / Case
32-TSOP
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Other names
AT29C010A15TI
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
AT29C010A-15TI
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
3. Block Diagram
4. Device Operation
4.1
4.2
4.3
4.4
0394i–FLASH–9/08
Read
Byte Load
Program
Software Data Protection
The AT29C010A is accessed like an EPROM. When CE and OE are low and WE is high, the
data stored at the memory location determined by the address pins is asserted on the outputs.
The outputs are put in the high impedance state whenever CE or OE is high. This dual-line con-
trol gives designers flexibility in preventing bus contention.
Byte loads are used to enter the 128 bytes of a sector to be programmed or the software codes
for data protection. A byte load is performed by applying a low pulse on the WE or CE input with
CE or WE low (respectively) and OE high. The address is latched on the falling edge of CE or
WE, whichever occurs last. The data is latched by the first rising edge of CE or WE.
The device is reprogrammed on a sector basis. If a byte of data within a sector is to be changed,
data for the entire sector must be loaded into the device. The data in any byte that is not loaded
during the programming of its sector will be indeterminate. Once the bytes of a sector are loaded
into the device, they are simultaneously programmed during the internal programming period.
After the first data byte has been loaded into the device, successive bytes are entered in the
same manner. Each new byte to be programmed must have its high to low transition on WE (or
CE) within 150 s of the low to high transition of WE (or CE) of the preceding byte. If a high to
low transition is not detected within 150 s of the last low to high transition, the load period will
end and the internal programming period will start. A7 to A16 specify the sector address. The
sector address must be valid during each high to low transition of WE (or CE). A0 to A6 specify
the byte address within the sector. The bytes may be loaded in any order; sequential loading is
not required. Once a programming operation has been initiated, and for the duration of t
read operation will effectively be a polling operation.
A software controlled data protection feature is available on the AT29C010A. Once the software
protection is enabled a software algorithm must be issued to the device before a program may
be performed. The software protection feature may be enabled or disabled by the user; when
AT29C010A
WC
, a
3