CAT25128YI-G ON Semiconductor, CAT25128YI-G Datasheet - Page 6

• Manufacturer Part Number: CAT25128YI-G
• Description: IC EEPROM 128KB SPI SER 8TSSOP
• Manufacturer: ON Semiconductor

Specifications of CAT25128YI-G

• Format - Memory: EEPROMs - Serial
• Memory Type: EEPROM
• Memory Size: 128K (16K x 8)
• Speed: 10MHz
• Interface: SPI, 3-Wire Serial
• Voltage - Supply: 1.8 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-TSSOP
• Organization: 16 K x 8
• Interface Type: SPI
• Maximum Clock Frequency: 10 MHz
• Access Time: 75 ns
• Supply Voltage (max): 5.5 V
• Supply Voltage (min): 1.8 V
• Maximum Operating Current: 4 mA
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 2.5 V, 3.3 V, 5 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

state. The device contains a Write Enable Latch (WEL)
which must be set before attempting to write to the memory
array or to the status register. In addition, the address of the
memory location(s) to be written must be outside the
protected area, as defined by BP0 and BP1 bits from the
status register.
Write Enable and Write Disable
Status Register WEL bit are set by sending the WREN
The CAT25128 device powers up into a write disable
The internal Write Enable Latch and the corresponding
SCK
SO
CS
SI
SCK
SO
CS
SI
Dashed Line = mode (1, 1)
Dashed Line = mode (1, 1)
0
0
Figure 3. WREN Timing
WRITE OPERATIONS
0
0
Figure 4. WRDI Timing
http://onsemi.com
0
0
HIGH IMPEDANCE
0
0
HIGH IMPEDANCE
6
0
0
instruction to the CAT25128. Care must be taken to take the
CS input high after the WREN instruction, as otherwise the
Write Enable Latch will not be properly set. WREN timing
is illustrated in Figure 3. The WREN instruction must be
sent prior to any WRITE or WRSR instruction.
WRDI instruction as shown in Figure 4. Disabling write
operations by resetting the WEL bit, will protect the device
against inadvertent writes.
1
The internal write enable latch is reset by sending the
1
1
0
0
0