M25P40-VMP6G NUMONYX, M25P40-VMP6G Datasheet - Page 21

• Manufacturer Part Number: M25P40-VMP6G
• Description: IC FLASH 4MBIT 50MHZ 8VFQFPN
• Manufacturer: NUMONYX
• Series: Forté™r

Specifications of M25P40-VMP6G

• Format - Memory: FLASH
• Memory Type: FLASH
• Memory Size: 4M (512K x 8)
• Speed: 50MHz
• Interface: SPI, 3-Wire Serial
• Voltage - Supply: 2.3 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-VFQFN, 8-VFQFPN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

6.3
Table 5.
Manufacturer identification
Read Identification (RDID)
The Read Identification (RDID) instruction reads the device identification data:
The manufacturer identification is assigned by JEDEC, and has the value 20h for Numonyx.
The device identification is assigned by the device manufacturer, and indicates the memory
type in the first byte (20h), and the memory capacity of the device in the second byte (13h).
The UID contains the length of the following data in the first byte (set to 10h), and 16 bytes
of the optional Customized Factory Data (CFD) content. The CFD bytes are read-only and
can be programmed with customers data upon their demand. If the customers do not make
requests, the devices are shipped with all the CFD bytes programmed to zero (00h). Any
Read Identification (RDID) instruction while an Erase or Program cycle is in progress, is not
decoded, and has no effect on the cycle that is in progress. The device is first selected by
driving Chip Select (S) Low. Then, the 8-bit instruction code for the instruction is shifted in.
After this, the 24-bit device identification, stored in the memory, the 8-bit CFD length
followed by 16 bytes of CFD content will be shifted out on Serial Data output (Q). Each bit is
shifted out during the falling edge of Serial Clock (C).
The instruction sequence is shown in
sequence and data-out
The Read Identification (RDID) instruction is terminated by driving Chip Select (S) High at
any time during data output.
When Chip Select (S) is driven High, the device is put in the Stand-by Power mode. Once in
the Stand-by Power mode, the device waits to be selected, so that it can receive, decode
and execute instructions.
Read Identification (RDID) data-out sequence
2. The UID feature is available only for 110 nm process technology devices, identified by process identification
20h
digit "4" in the device marking and process letter "B" in the part number.
Manufacturer identification (1 byte)
Device identification (2 bytes)
Unique ID code (UID) (17 bytes, 16 which are available upon customer request).
Memory type
sequence.
20h
Device identification
Figure 9: Read Identification (RDID) instruction
Memory capacity
13h
CFD length
10h
UID
CFD content
16 bytes
(2)
21/61