MAX17501ETEEVKIT# Maxim Integrated, MAX17501ETEEVKIT# Datasheet - Page 2

• Manufacturer Part Number: MAX17501ETEEVKIT#
• Description: Power Management IC Development Tools MAX17501E/F Eval Kit
• Manufacturer: Maxim Integrated
• Type: DC/DC Converters, Regulators & Controllersr
• Series: MAX17501r

Specifications of MAX17501ETEEVKIT#

• Rohs: yes
• Product: Evaluation Kits
• Tool Is For Evaluation Of: MAX17501E, MAX17501F
• Input Voltage: 4.5 V to 60 V
• Output Voltage: 3.3 V
• Output Current: 500 mA
• For Use With: MAX17501E, MAX17501F

*EP = Exposed pad.
Note: Indicate that you are using the MAX17501 when contacting these component suppliers.
• MAX17501A or MAX17501E EV kit
• 4.5V to 60V, 1A DC input power supply
• Load capable of sinking 500mA
• Digital voltmeter (DVM)
• Function generator
The EV kits are fully assembled and tested. Follow the steps
below to verify board operation. Caution: Do not turn on
power supply until all connections are completed.
1) Set the power supply at a voltage between 4.5V and
2) Connect the positive terminal of the power supply
3) Connect the DVM across the VOUT PCB pad and the
Coilcraft, Inc.
Murata Electronics North America, Inc.
Panasonic Corp.
60V. Disable the power supply.
to the VIN PCB pad and the negative terminal to the
nearest PGND PCB pad. Connect the positive termi-
nal of the 500mA load to the VOUT PCB pad and the
negative terminal to the nearest PGND PCB pad.
nearest PGND PCB pad.
MAX17501ATEVKIT#
MAX17501ETEVKIT#
EV KIT
SUPPLIER
Recommended Equipment
Evaluate: MAX17501A/MAX17501E
Quick Start
DESIGNATION
Procedure
U1
U1
—
—
847-639-6400
770-436-1300
800-344-2112
PHONE
4) Verify that a shunt is installed across pins 1-2 on
5) Turn on the DC power supply.
6) Enable the load.
7) Verify that the DVM displays the expected voltage.
To turn on/turn off the part from EN/UVLO, follow the
steps below:
1) Remove resistors R1 and R2 and the jumper installed
2) Connect the power supply to the EV kit and turn on
3) Connect the function generator output to the
4) EN/UVLO rising threshold is 1.24V and falling thresh-
5) When powering down the EV kits, first disconnect the
jumper JU1.
across pins 1-2 on jumper JU1.
the power supply. Set the power supply at a voltage
between 4.5V and 60V.
EN/UVLO test loop.
old is 1.11V. Make sure that the voltage-high and
voltage-low levels of the function generator output are
greater than 1.24V and less than 1.11V, respectively.
function generator output from the EN/UVLO test loop
and then turn off the DC power supply.
Buck converter (10 TDFN-EP*)
Maxim MAX17501AATB+
PCB: MAX17501AT EVALUATION KIT
Buck converter (10 TDFN-EP*)
Maxim MAX17501EATB+
PCB: MAX17501ET EVALUATION KIT
in TDFN Packages
www.coilcraft.com
www.murata-northamerica.com
www.panasonic.com
EV Kit-Specific Component List
Component Suppliers
DESCRIPTION
WEBSITE
2