ZICM357P2-2C CEL, ZICM357P2-2C Datasheet - Page 13

• Manufacturer Part Number: ZICM357P2-2C
• Description: Zigbee / 802.15.4 Modules MeshConnect Module 2405-2480MHz
• Manufacturer: CEL

Specifications of ZICM357P2-2C

• Rohs: yes
• Frequency Band: 2.405 GHz to 2.48 GHz
• Line Of Sight Range: 13000 ft
• Data Rate: 250 kbps
• Sensitivity: - 100 dBm
• Operating Supply Voltage: 3.3 V
• Supply Current Transmitting: 170 mA
• Supply Current Receiving: 28 mA
• Output Power: 20 dBm
• Antenna Connector Type: U.FL
• Maximum Operating Temperature: + 85 C
• Dimensions: 1.4 in x 1 in x 0.195 in
• Minimum Operating Temperature: - 40 C

Wave Soldering
If a wave soldering process is required on the host boards due to the presence of leaded components, only a
single wave soldering process is encouraged.
Hand Soldering
Hand soldering is possible. When using a soldering iron, follow IPC recommendations (reference document IPC-
7711).
Rework
The MeshConnect Module can be unsoldered from the host board. Use of a hot air rework tool should be pro-
grammable and the solder joint and module should not exceed the maximum peak reflow temperature of 250ºC.
Caution
If temperature ramps exceed the reflow temperature profile, module and component damage may occur due to
thermal shock. Avoid overheating.
Warning
Never attempt a rework on the module itself, (e.g. replacing individual components). Such actions will
terminate warranty coverage.
Additional Grounding
Attempts to improve module or system grounding by soldering braids, wires, or cables onto the module RF shield
cover is done at the customer's own risk. The numerous ground pins at the module perimeter should be sufficient
for optimum immunity to external RF interference.
AGENCy CERTIFICATIONS
FCC Compliance Statement (Part 15.19) Section 7.15 of RSS-GEN
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
Warning (Part 15.21)
Changes or modifications not expressly approved by CEL could void the user's authority to operate the equipment.
20 cm Separation Distance
To comply with FCC/IC RF exposure limits for general population/uncontrolled exposure, the antenna(s) used for
this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not
be co-located or operating in conjunction with any other antenna or transmitter.
OEM Responsibility to the FCC Rules and Regulations
The MeshConnect Module has been certified per FCC Part 15 Rules for integration into products without further
testing or certification. To fulfill the FCC Certification requirements, the OEM of the MeshConnect Module must
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
operation.
susceptible d'en compromettre le fonctionnement.
MeshConnect™ EM357 Module
Page 13