XB24-BPIT-004 Digi International, XB24-BPIT-004 Datasheet - Page 88

• Manufacturer Part Number: XB24-BPIT-004
• Description: Zigbee / 802.15.4 Modules XBee Series 2 w/PCB Ant
• Manufacturer: Digi International

Specifications of XB24-BPIT-004

• Rohs: yes
• Frequency Band: 2.4 GHz
• Line Of Sight Range: 100 m
• Data Rate: 250 Kbps
• Sensitivity: - 102 dBm
• Operating Supply Voltage: 3 V to 3.4 V
• Output Power: 63 mW
• Antenna Connector Type: PCB
• Maximum Operating Temperature: + 85 C

XBee ZNet 2.5/XBee‐PRO ZNet 2.5 ZigBee OEM RF Modules v1.x4x
OEM Labeling Requirements
Restrictions
Declarations of Conformity
Approved Antennas
Furthermore, the manufacturer must maintain a copy of the XBee ZNet 2.5 user manual
documentation and ensure the final product does not exceed the specified power ratings, antenna
specifications, and/or installation requirements as specified in the user manual. If any of these
specifications are exceeded in the final product, a submission must be made to a notified body for
compliance testing to all required standards.
The 'CE' marking must be affixed to a visible location on the OEM product.
Figure B‐01. CE Labeling Requirements
The CE mark shall consist of the initials "CE" taking the following form:
Power Output: The power output of the XBee ZNet 2.5 RF Module must not exceed 10 dBm. The
power level is set using the PL command and the PL parameter must equal “0” (10 dBm).
France: France imposes restrictions on the 2.4 GHz band. Go to www.art-telecom.Fr or contact
MaxStream for more information.
Norway: Norway prohibits operation near Ny-Alesund in Svalbard. More information can be found
at the Norway Posts and Telecommunications site (www.npt.no).
Digi has issued Declarations of Conformity for the XBee ZNet 2.5 RF Modules concerning
emissions, EMC and safety. Files are located in the 'documentation' folder of the Digi CD.
Important Note
Digi does not list the entire set of standards that must be met for each country. Digi customers
assume full responsibility for learning and meeting the required guidelines for each country in their
distribution market. For more information relating to European compliance of an OEM product
incorporating the XBee ZNet 2.5 RF Module, contact Digi, or refer to the following web sites:
CEPT ERC 70-03E - Technical Requirements, European restrictions and general requirements:
Available at www.ero.dk/.
R&TTE Directive - Equipment requirements, placement on market: Available at www.ero.dk/.
When integrating high-gain antennas, European regulations stipulate EIRP power maximums. Use
the following guidelines to determine which antennas to design into an application.
XBee ZNet 2.5 OEM Module
The following antennas types have been tested and approved for use with the XBee ZNet 2.5
Module:
Antenna Type: Yagi
RF module was tested and approved with 15 dBi antenna gain with 1 dB cable-loss (EIRP Maimum
of 14 dBm). Any Yagi type antenna with 14 dBi gain or less can be used with no cable-loss.
© 2008 Digi International, Inc.
• If the CE marking is reduced or enlarged, the proportions given in the above graduated draw-
• The CE marking must have a height of at least 5mm except where this is not possible on
• The CE marking must be affixed visibly, legibly, and indelibly.
ing must be respected.
account of the nature of the apparatus.
87