SCC1300-D02DEMO Murata Electronics, SCC1300-D02DEMO Datasheet - Page 3

• Manufacturer Part Number: SCC1300-D02DEMO
• Description: Acceleration Sensor Development Tools SCC1300-D02 Demo Board
• Manufacturer: Murata Electronics

Specifications of SCC1300-D02DEMO

• Tool Is For Evaluation Of: SCA1300-D02
• Acceleration: 2 g
• Sensing Axis: Triple Axis
• Interface Type: SPI
• Operating Voltage: 3 V to 3.6 V
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Operating Current: 24 mA
• Output Type: Analog and Digital

1
2
VTI Technologies Oy
www.vti.fi
Introduction
Quick Start for Using the SCC1300 Demo Kit
SCC1300 demo demonstrates the SCC1300 component functionality and the component key
properties. This document describes how to install the required software and how to use the
SCC1300 demo board and Graphical User Interface (GUI) software.
SCC1300 demo consists of:
SCC1300 demo runs on recent Windows versions (Windows 7, Vista, XP and 2000) and it requires
USB connection for data transfer. Demo is powered from USB port. The SCC1300 demo is based
on the same USB hardware PCB as the SCA3000 Demo Kit, however please note that the original
SCA3000 Demo PCB is not compatible with SCC1300. The same USB driver can be used with all
demo kits provided by VTI Technologies.
Please follow the steps below:
When using the SCC1300 Demo Kit with GUI software:
During software start up, the firewall may alert that the demo software wants a network access.
The demo software can be operated without the network access (granting the network access will
not change the software operation).
•
•
•
•
1. Insert CD-ROM
2. Setup the hardware
3. Install the USB driver, after the PC has found the device
4. Install the GUI software
5. Start the GUI software
• The Demo Kit should be connected to PC before the GUI software is started
• Exit the GUI software before unplugging the Demo Kit from PC
• After GUI software is stopped, the Demo Kit can be unplugged from PC (Demo Kit uses
virtual serial port driver, so it can not be found as a USB device).
SCC1300 sensor soldered on a chip carrier PWB (see Figure 1 on next page)
USB interface card (see Figure 1 on next page)
USB cable
GUI software running on PC
-
-
-
-
-
-
Connect the demo kit to PC's USB port
Let Windows to install the USB driver, if the driver is not found an executable
installer can be run from folder "CD-ROM\SCC1300 demo - Virtual Com
Port Drivers\”
NOTICE, if you have already installed some other demo kit provided by VTI
Technologies, please check that the latency timer parameter is 5 ms. In case the
latency timer value is greater than 5 ms, the SCC1300 Demo Kit GUI will not work
(more detailed instructions in section 8)
Install the GUI software by running the “setup.exe" from folder:
CD-ROM\SCC1300 demo – GUI Installer
Do not change the installation destination
From Start → Programs → SCC1300-USB-DEMO-VER-1.0 →
SCC1300-USB-DEMO-VER-1.0
Doc.Nr. 82117600.01
SCC1300 GYRO-COMBO DEMO KIT
User Manual
Rev.0.1
3/19