A000064 Arduino, A000064 Datasheet - Page 3

• Manufacturer Part Number: A000064
• Description: RF Development Tools ARDUINO SHIELD WIRELESS PROTO
• Manufacturer: Arduino
• Type: Communication & Networkingr

Specifications of A000064

• Rohs: yes
• Product: Wireless SD Shields
• Tool Is For Evaluation Of: XB24x
• Frequency: 2.4 GHz
• Description/function: Wireless SD shield allows an Arduino board to communicate wirelessly using a wireless module
• Interface Type: Serial, USB

Here are some of the more useful parameters for configuring your Xbee module. For step-by-step
instructions on reading and writing them using AT commands, see the:
Make sure to prepend AT to the parameter name when sending a command to the module (e.g. to read
the ID parameter, you should send the command ATID).
Command Description
ID
CH
SH and SL The serial number of the XBee module (SH gives the
MY
DH and DL The destination address for wireless communication
BD
Note: although the valid and default values in the table above are written with a prefix of "0x" (to indicate
that they are hexadecimal numbers), the module will not include the "0x" when reporting the value of a
parameter, and you should omit it when setting values.
Here are a couple more useful commands for configuring the XBee module (you'll need to prepend AT to
these too).
Command Description
RE
WR
CN
For more details on configuring the XBee module, see the
modules product manual


guide to the Wireless shield with the 802.15.4
guide to the Wireless shield with the ZNet 2.5
The network ID of the XBee module.
The channel of the XBee module.
high 32 bits, SL the low 32 bits). Read-only.
The 16-bit address of the module.
(DH is the high 32 bits, DL the low 32).
The baud rate used for serial communication with
the Arduino board or computer.
Restore factory default settings (note that like
parameter changes, this is not permanent unless
followed by the WR command).
Write newly configured parameter values to non-
volatile (long-term) storage. Otherwise, they will
only last until the module loses power.
Exit command mode now. (If you don't send any
commands to the module for a few seconds,
command mode will timeout and exit even without a
CN command.)
from Digi International.
modules.
modules.
802.15.4 modules product manual
Valid Values
0x0B - 0x1A
0 - 0xFFFFFFFF
(for both SH and SL)
0 - 0xFFFFFFFF
(for both DH and DL)
0 (1200 bps)
1 (2400 bps)
2 (4800 bps)
3 (9600 bps)
4 (19200 bps)
5 (38400 bps)
6 (57600 bps)
7 (115200 bps)
0 - 0xFFFF
0 - 0xFFFF
Default Value
3332
0X0C
different for each
module
0
0 (for both DH and
DL)
3 (9600 baud)
or the
ZB