EVM-915-250-FCR Linx Technologies, EVM-915-250-FCR Datasheet - Page 7

• Manufacturer Part Number: EVM-915-250-FCR
• Description: RF Development Tools 900 MHz Wireless FCC Module FHSS 250 mW
• Manufacturer: Linx Technologies
• Type: Wi-Fir

Specifications of EVM-915-250-FCR

• Rohs: yes
• Product: Evaluation Modules
• Tool Is For Evaluation Of: Wi.232FHSS-250
• Frequency: 915 MHz
• Operating Supply Voltage: 2.7 V to 3.6 V
• Interface Type: UART
• Factory Pack Quantity: 1

Usage Guidelines for FCC Compliance
The EVM-915-250-FCx modules have been awarded a FCC and IC
modular approval. The EVM-915-250-BZx have passed Anatel
compliance testing. That means that this module, when integrated into your
end product, requires no FCC part 15 or IC RSS-210 testing as long as the
following guidelines are met. Failure to meet any of the following guidelines
will prevent the inheritance of the FCC and IC modular certifications.
Antenna Selection
In order to maintain compliance with FCC, Industry Canada and Anatel
regulations, an antenna with no more than 3dBi gain must be used. This
module has been tested with the following antennas:
Figure 7: Antenna Selection
An approved antenna must be directly attached to the module’s
reverse-polarity SMA connector or through an approved shielded coaxial
extension cable in the final application to inherit the FCC and IC modular
certifications.
Module Modification
The module must not be physically altered in any way. If any connections
are made to the modules that bypass the module pins, socket or antenna
connector, the certifications cannot be inherited.
End Product labeling Requirements
Pursuant to FCC public notice DA 00-1407, the end product must be
labeled on its exterior with the following:
“Contains FCC ID: Q7V-3F090009X”
Preliminary Draft
Antenna Selection
Link Part No.
ANT-916-CW-HW
Antenna Type
RP ½ Wave Dipole
–
8
Antenna gain
2.5dBi
–
Additional FCC Testing Requirements
While the module’s FCC certification can be inherited if the guidelines are
met, additional testing will be required to achieve full FCC compliance for
the end-product. The integrator is required to perform unintentional
radiator testing on the final product per FCC sections 15.107 and 15.109.
Additional product-specific testing might be required. Please contact the
FCC regarding regulatory requirements for your application. Ultimately is it
the integrator’s responsibility to show that their product complies with the
regulations applicable to their product.
–
9
–
Preliminary Draft