MAX6956EVKIT+ Maxim Integrated, MAX6956EVKIT+ Datasheet - Page 3

• Manufacturer Part Number: MAX6956EVKIT+
• Description: LED Lighting Development Tools Evaluation Kit for the MAX6956
• Manufacturer: Maxim Integrated
• Series: MAX6956r

Specifications of MAX6956EVKIT+

• Product: Evaluation Kits

2) Install the EV kit software on your computer by run-
3) Verify jumper settings (see Table 1).
4) Connect the USB cable from the PC to the EV kit
5) Follow the directions of the Add New Hardware
Table 1. Jumper Selection (JU1–JU14)
* Default position.
JUMPER
ning the INSTALL.EXE program inside the temporary
folder. The program files are copied and icons are
created in the Windows Start | Programs menu.
board. A Building Driver Database window pops
up in addition to a New Hardware Found message
when installing the USB driver for the first time. If you
do not see a window that is similar to the one
described above after 30 seconds, remove the USB
cable from the board and reconnect it. Administrator
privileges are required to install the USB device dri-
ver on Windows 2000/XP and Windows Vista.
Wizard to install the USB device driver. Choose the
Search for the best driver for your device option.
JU1
JU2
JU3
JU4
JU5
JU6
JU7
JU8
FUNCTION
translator
translator
VLED
Level
Level
AD0
AD1
P31
P30
V+
_______________________________________________________________________________________
PCB trace cut open
PCB trace cut open
SHUNT POSITION
Not installed*
Not installed*
1-2*
1-2*
1-2*
1-2*
1-2*
1-2*
3-4
5-6
7-8
2-3
3-4
5-6
7-8
2-3
2-3
2-3
I
U1 V+ powered by VDDIO 3.3V
U1 V+ from external power EXT_V+
I
VLED powered by VDDIO 3.3V
VLED from external power EXT_VLED
SDA connects directly to MAXQ2000
See the Operation with External 2.5V to 5.5V Supply section
SCL connects directly to MAXQ2000
See the Operation with External 2.5V to 5.5V Supply section
U1 P31 port connected to LED2 right decimal point
U1 P31 port connected to interrupt input and LED15
U1 P30 port connected to LED2 left decimal point; pushbutton switch is not
used
U1 P30 port connected to switch SW1
2
2
C address selection (see Table 2)
C address selection (see Table 2)
MAX6956 Evaluation Kit
6) Start the MAX6956 EV kit software by opening its
7) Press function key F1 to configure all of the ports for
Specify the location of the device driver to be
C:\Program Files\MAX6956 (default installation
directory) using the Browse button. During device
driver installation, Windows may show a warning
message indicating that the device driver Maxim
uses does not contain a digital signature. This is not
an error condition and it is safe to proceed with
installation. Refer to the USB_Driver_Help.PDF docu-
ment included with the software for additional infor-
mation.
icon in the Start | Programs menu. The EV kit soft-
ware main window appears, as shown in Figure 1.
LED output and enter display test mode. Verify that
all of the LEDs light up. Click OK to end display test
mode.
DESCRIPTION
Jumper Selection
3