UMFT221XE-01 FTDI, UMFT221XE-01 Datasheet - Page 15

• Manufacturer Part Number: UMFT221XE-01
• Description: Interface Development Tools USB to 8-Bit SPI FT1248 Mod.
• Manufacturer: FTDI
• Type: USB to SPIr
• Series: FT221Xr

Specifications of UMFT221XE-01

• Rohs: yes
• Product: Development Modules
• Tool Is For Evaluation Of: FT221XQ
• Interface Type: I2C, SPI, USB
• Operating Supply Voltage: 3.3 V
• Description/function: USB to 8bit SPI evaluation module
• Dimensions: 29.02 mm x 19.24 mm x 9.2 mm
• Operating Supply Current: 1 A
• Factory Pack Quantity: 25
• For Use With: FT221XQ

8
Following a power-on reset or a USB reset the FT221X will scan its internal MTP ROM and read the USB
configuration descriptors stored there. The default values programmed into the internal MTP ROM in the
FT221XQ used on the UMFT221XE are shown in Table 8.1.
Parameter
USB Vendor ID (VID)
USB Product UD (PID)
Binary Code Decimal
(BCD)
Serial Number Enabled?
Serial Number
Pull down I/O Pins in
USB Suspend
Manufacturer Name
Product Description
Max Bus Power Current
Power Source
Device Type
USB Version
Remote Wake Up
High Current I/Os
Load VCP Driver
CBUS3
Table 8.1 – Default Internal MTP ROM Configuration
The internal MTP ROM in the FT221X can be programmed over USB using the utility program FT_PROG.
FT_PROG can be downloaded from the www.ftdichip.com. Users who do not have their own USB vendor
ID but who would like to use a unique Product ID in their design can apply to FTDI for a free block of
unique PIDs. Contact
TN_101.
Internal MTP ROM Configuration
FTDI Support
Value
0403h
6015h
1000h
Yes
See Note
Disabled
FTDI
UMFT221XE
90mA
Bus Powered
FT221X
0200
Enabled
Disabled
Enabled
Tristate
([e-mail]) for this service, also see
Copyright © 2012 Future Technology Devices International Limited
Notes
FTDI default VID (hex)
FTDI default PID (hex)
FTDI default BCD (hex)
A unique serial number is generated and programmed into the
MTP ROM during final test of the module.
Enabling this option will make the device pull down on the I2C
interface lines when the power is shut off (PWREN# is high).
Returns USB 2.0 device description to the host. Note: The
device is a USB 2.0 Full Speed device (12Mb/s) as opposed to
a USB 2.0 High Speed device (480Mb/s).
Taking RI# low will wake up the USB host controller from
suspend.
Enables the high drive level on the data and CBUS I/O pins.
Makes the device load the CVP driver interface for the device.
Document Reference No.: FT_000651
TN_100
Clearance No.: FTDI#
15
UMFT221XE
Version 1.0
and
293