MAX1363EVKIT Maxim Integrated, MAX1363EVKIT Datasheet - Page 6

• Manufacturer Part Number: MAX1363EVKIT
• Description: Data Conversion IC Development Tools Evaluation Kit for the MAX1361/MAX1363
• Manufacturer: Maxim Integrated
• Series: MAX1363, MAX1364r

Specifications of MAX1363EVKIT

• Interface Type: I2C, Serial
• Operating Supply Voltage: 2.7 V to 3.6 V

The ADC Value Display box shown in the main window
displays the channel number (CH#), the voltage, and the
code. Pressing the Read ADC button updates the status
of the ADC Value Display box. There may be lines in the
ADC Value Display box that are grayed out due to the
Setup Byte and Configuration Byte settings.
Check the Auto Read checkbox to automatically read
the current ADC value at a rate set by the Timer
Interval pulldown menu. When this Auto Read check-
box is checked, the Read ADC button is disabled.
The Interrupt Status indicator is located in the lower
right of the main window. It indicates the current status
of the MAX1363’s interrupt pin and is updated at a rate
based on the value in the Timer Interval pulldown
menu. The hardware interrrupt is active only when
INT_EN is checked in the Configuring Monitor Mode
window.
When an interrupt occurs, the INT LED on the MAX1363
EV kit board lights up in real time.
When the Send SMBus Alert button is pressed, the
SMBus Alert window pops up and displays the alert-
device address as shown in
alarm, the Alert Device Address field shows the high-
est SMBus address, which is 0xfe.
Accessing the Action | Block Sample menu results in
the Block Sampling window popping up as shown in
Figure
sampling length. Pressing the Sample button starts
sampling and changes the Configuration Byte |
D6 - D5 pulldown menu to 11 SCAN1 SCAN0 single
conversion. After sampling is finished, the user can
save the data to a file by pressing the Save button. The
Save button is not active until the sampling is done.
MAX1363 Evaluation Kit
6
_______________________________________________________________________________________
5. The user can change the sample rate and
ADC Data Block Sampling
Figure
ADC Value Display
4. If there is no
SMBus Alert
Interrupt
Figure 4. SMBus-Alert Window
Figure 5. Block-Sampling Window