S-24CS08ADP-1G Seiko Instruments, S-24CS08ADP-1G Datasheet - Page 20

• Manufacturer Part Number: S-24CS08ADP-1G
• Description: IC EEPROM 8KBIT 400KHZ 8DIP
• Manufacturer: Seiko Instruments

Specifications of S-24CS08ADP-1G

• Format - Memory: EEPROMs - Serial
• Memory Type: EEPROM
• Memory Size: 8K (1K x 8)
• Speed: 400kHz
• Interface: I²C, 2-Wire Serial
• Voltage - Supply: 1.8 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-DIP
• Organization: 1 K x 8
• Interface Type: 2-Wire
• Maximum Clock Frequency: 0.4 MHz
• Supply Voltage (max): 5.5 V
• Supply Voltage (min): 1.8 V
• Maximum Operating Current: 4 mA
• Maximum Operating Temperature: + 85 C
• Mounting Style: Through Hole
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 5.5 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

20
2-WIRE CMOS SERIAL E
S-24CS01A/02A/04A/08A
1. Adding a pull-up resistor to SDA I/O pin and SCL input pin
2. I/O pin equivalent circuit
Using S-24CS01A/02A/04A/08A
Add a 1 to 5 k Ω pull-up resistor to the SCL input pin
of the I
*1. When the SCL input pin of the E
The I/O pins of this IC do not include pull-up and pull-down resistors. The SDA pin is an open-drain output.
The following shows the equivalent circuits.
connect the same pull-up resistor to prevent a high impedance status from being input to the SCL
input pin.
This protects the E
state pin when the microprocessor is reset when the voltage drops.
2
C-bus protocol. Normal communication cannot be provided without a pull-up resistor.
SCL
SDA
2
PROM from malfunction due to an undefined output (high impedance) from the tri-
2
PROM
2
PROM is connected to a tri-state output pin of the microprocessor,
Seiko Instruments Inc.
Figure 23 SDA Pin
Figure 22 SCL Pin
*1
and the SDA I/O pin in order to enable the functions
Rev.4.5
_00