EA-QSB-015 Embedded Artists, EA-QSB-015 Datasheet - Page 15

• Manufacturer Part Number: EA-QSB-015
• Description: Development Boards & Kits - ARM QUICK START BOARD LPC11U35
• Manufacturer: Embedded Artists

Specifications of EA-QSB-015

• Rohs: yes
• Product: Development Kits
• Tool Is For Evaluation Of: LPC11U35
• Core: ARM Cortex M0
• Interface Type: USB
• Operating Supply Voltage: 3.3 V

Copyright 2012 © Embedded Artists AB
LPC11U35 QuickStart Board - User’s Guide
5 Getting Started
The chapter gives some pointer about how to get started with the LPC11U35 QuickStart Board
hardware. It does not describe how program development is done. For information about how to get
started with program development in general, see the LPCXpresso IDE documentation:
www.nxp.com/lpcxpresso. LPCXpresso is a concept from NXP, containing both a program
development environment (LPCXpresso IDE) and target boards (jointly developed by Embedded
Artists). The target boards also contain a SWD/JTAG interface, called the LPC-LINK. The LPCXpresso
IDE is free and well-supported on the LPCXpresso forum. It is recommended to use for program
development on the LPC11U35 QuickStart Board.
Sample applications for the LPC11U35 QuickStart Board can be downloaded from the Embedded
Artists support site. These samples have been developed in the LPCXpresso IDE.
5.1
The SWD interface is the recommended interface to use for program development, including
debugging. Any SWD/JTAG debug interface that supports ARM Cortex-M0 processors will work.
Figure 4 below shows how the LPC-LINK (part of an LPCXpresso target board) is connected to the
SWD interface of the LPC11U35 QuickStart Board. Note the orientation of the SWD cable in the
LPC11U35 end. Pin 1 of the SWD connector (J4) is at the board edge, see picture below. This is
because the orientation of the SWD/JTAG connector on the LPC-LINK board.
Figure 4 – LPC11U35 QuickStart Board connected to LPC-LINK, via SWD
SWD Interface
Pin 1 of J4
J4 pinning
10
8
6
4
2
Page 15
9
7
5
3
1