EV-ADF4360-9EB1Z Analog Devices, EV-ADF4360-9EB1Z Datasheet - Page 7
![no-image](/images/manufacturer_photos/0/0/56/analog_devices_sml.jpg)
EV-ADF4360-9EB1Z
Manufacturer Part Number
EV-ADF4360-9EB1Z
Description
Clock & Timer Development Tools EVALUATION BOARD
Manufacturer
Analog Devices
Type
PLL Synthesizers / Multipliers / Dividersr
Datasheet
1.EV-ADF4360-9EB1Z.pdf
(16 pages)
Specifications of EV-ADF4360-9EB1Z
Rohs
yes
Product
Evaluation Boards
Tool Is For Evaluation Of
ADF4360-9
Frequency
250 MHz, 400 MHz
Operating Supply Voltage
9 V
Interface Type
USB
Operating Supply Current
40 mA
Factory Pack Quantity
1
Evaluation Board User Guide
USING THE EVALUATION BOARD SOFTWARE
The control software for the
the
the Evaluation Board Software Quick Start Procedures section.
To run the software, double-click the ADF4360.exe file on the
desktop or from the Start menu.
The main interface window opens (see Figure 10). Confirm that
Analog Devices RFG.L Eval Board connected is displayed at
the top of the window. Otherwise, the software has no connection
to the evaluation board.
The evaluation board can be connected and disconnected while
the software is running. Note that when connecting the board,
it takes about 5 seconds for the status label to change.
Under the File menu, the current settings can be saved to, and
loaded from, a text file.
Use the REF IN Frequency text box to set the correct reference
frequency and the reference frequency divider. The reference
TCXO on the evaluation board runs at 19.2 MHz.
The Settings section controls the charge pump current setting,
the output power setting, and the multiplexer output setting.
EV-ADF4360-9EB1Z
on a CD. To install the software, see
EV-ADF4360-9EB1Z
accompanies
Rev. C | Page 7 of 16
Use the Frequency Settings section to control the output
frequency. You can input the desired output frequency
in the RF Output Frequency text box (in megahertz). Div Out
Frequency displays the VCO output frequency available from
the output divider.
In the Registers tab, you can manually input the desired value
to be written to the registers.
In the Sweep and hop tab, you can make the device sweep a
range of frequencies or hop between two set frequencies.
In the Latches to write section at the bottom of the window, the
values to be written to each register are displayed. If the
background on the text box is green, the value displayed is
different from the value actually on the device. Click Write N
counter Latch or Write R counter Latch to write that value to
the device.
Press the F2, F3, and F4 keys to switch between the three tabs.
F12 increases the output frequency by one channel spacing and
writes it to the device. F11 decreases the output frequency by
one channel spacing.
UG-106