AT88SC1616C-MPTG Atmel, AT88SC1616C-MPTG Datasheet - Page 12

• Manufacturer Part Number: AT88SC1616C-MPTG
• Description: CRYPTOMEM 16KBIT 16ZONE MOD P TW
• Manufacturer: Atmel
• Series: CryptoMemory®r

Specifications of AT88SC1616C-MPTG

• Format - Memory: EEPROMs - Serial
• Memory Type: EEPROM
• Memory Size: 16K (2K x 8)
• Speed: 5MHz
• Interface: I²C, 2-Wire Serial
• Voltage - Supply: 2.7 V ~ 5.5 V
• Operating Temperature: 0°C ~ 70°C
• Package / Case: M2 P, Smart Card Module
• Operating Temperature (max): 70C
• Operating Temperature (min): 0C
• Operating Temperature Classification: Commercial
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

13.
13.1. Anti-tearing
13.2.
12
Security Options
In the event of a power loss during a write cycle, the integrity of the device’s stored data may be recovered. This
function is optional: the host may choose to activate the anti-tearing function, depending on application requirements.
When anti-tearing is active, write commands take longer to execute, since more write cycles are required to complete
them, and data are limited to eight bytes.
Data are written first to a buffer zone in EEPROM instead of the intended destination address, but with the same
access conditions. The data are then written in the required location. If this second write cycle is interrupted due to a
power loss, the device will automatically recover the data from the system buffer zone at the next power-up.
In 2-wire mode, the host is required to perform ACK polling for up to 8 ms after write commands when anti-tearing is
active. At power-up, the host is required to perform ACK polling, in some cases for up to 2 ms, in the event that the
device needs to carry out the data recovery process.
Write Lock
If a user zone is configured in the write lock mode, the lowest address byte of an 8-byte page constitutes a write access
byte for the bytes of that page.
Example
The write lock byte at $080 controls the bytes from $080 to $087.
Figure 12.
The write lock byte may also be locked by writing its least significant (rightmost) bit to “0”. Moreover, when write lock
mode is activated, the write lock byte can only be programmed – that is, bits written to “0” cannot return to “1”. In the
write lock configuration, only one byte can be written at a time. Even if several bytes are received, only the first byte will
be taken into account by the device.
AT88SC1616C
Address
$080
Write Lock Example
11011001
$0
xxxx xxxx
locked
$1
xxxx xxxx
locked
$2
xxxx xxxx
$3
xxxx xxxx
$4
xxxx xxxx
locked
$5
xxxx xxxx
$6
2030KS–SMIC–10/09
xxxx xxxx
$7