AT88SC0104CA-PU Atmel, AT88SC0104CA-PU Datasheet - Page 25
![IC EEPROM 1KBIT 4MHZ 8DIP](/photos/6/50/65033/313-8-dip_sml.jpg)
AT88SC0104CA-PU
Manufacturer Part Number
AT88SC0104CA-PU
Description
IC EEPROM 1KBIT 4MHZ 8DIP
Manufacturer
Atmel
Series
CryptoMemory®r
Specifications of AT88SC0104CA-PU
Format - Memory
EEPROMs - Serial
Memory Type
EEPROM
Memory Size
1K (128 x 8)
Speed
4MHz
Interface
I²C, 2-Wire Serial
Voltage - Supply
2.7 V ~ 3.6 V
Operating Temperature
-40°C ~ 85°C
Package / Case
8-DIP (0.300", 7.62mm)
For Use With
AT88SC-SDK1 - KIT TUEMA DK CRYPTOMEM SMARTCARDAT88SC-DK1 - KIT DEV FOR AT88SCXXXXC FAMILY
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
7.
7.1.
24
Protocol Selection
Atmel
communication for embedded applications and an ISO 7816 asynchronous T=0 smart card interface. The power-up
sequence of CryptoMemory determines what mode it shall operate in. A brief description of each of these modes
follows.
Synchronous Mode for Embedded Applications
The 2-wire serial interface is used for fast and efficient communication with logic and controllers. The synchronous
mode is the default after powering up V
applications using CryptoMemory in standard plastic packages RST is not bonded out and this is the only
communication protocol.
• Power-up V
• After stable V
• CLK-SCL and I/O-SDA may then be driven.
Figure 9. Asynchronous Mode
CLK-SCL
The asynchronous mode is selected when RST is low on a rising edge of CLK. Once the asynchronous mode has been
selected, it is not possible to return to the synchronous mode other than by powering the device off and on again.
Atmel AT88SC0104/0204/0404/0808/CA
I/O-SDA
RST
®
V cc
CryptoMemory
CC
CC
, RST goes high also.
, apply five pulses CLK-SCL
®
supports two application areas with different communication protocols: a 2-wire serial
1
2
3
CC
due to the internal and/or external pull-up on RST. For embedded
4
5
8664C–CRYPT–01/10