M45PE20-VMN6P NUMONYX, M45PE20-VMN6P Datasheet - Page 31

• Manufacturer Part Number: M45PE20-VMN6P
• Description: IC FLASH 2MBIT 75MHZ 8SOIC
• Manufacturer: NUMONYX
• Series: Forté™r

Specifications of M45PE20-VMN6P

• Format - Memory: FLASH
• Memory Type: FLASH
• Memory Size: 2M (256K x 8)
• Speed: 75MHz
• Interface: SPI, 3-Wire Serial
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-SOIC (3.9mm Width)
• Clock Frequency: 75MHz
• Supply Voltage Range: 2.7V To 3.6V
• Memory Case Style: SO
• No. Of Pins: 8
• Base Number: 45
• Frequency: 75MHz
• Ic Generic Number: 45PE20
• Memory Configuration: 256K X 8
• Interface Type: Serial, SPI
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

M45PE20
6.12
Release from deep power-down (RDP)
Once the device has entered the deep power-down mode, all instructions are ignored
except the release from deep power-down (RDP) instruction. Executing this instruction
takes the device out of the deep power-down mode.
The release from deep power-down (RDP) instruction is entered by driving Chip Select (S)
Low, followed by the instruction code on serial data input (D). Chip Select (S) must be driven
Low for the entire duration of the sequence.
The instruction sequence is shown in
The release from deep power-down (RDP) instruction is terminated by driving Chip Select
(S) High. Sending additional clock cycles on Serial Clock (C), while Chip Select (S) is driven
Low, cause the instruction to be rejected, and not executed.
After Chip Select (S) has been driven High, followed by a delay, t
standby power mode. Chip Select (S) must remain High at least until this period is over. The
device waits to be selected, so that it can receive, decode and execute instructions.
Any release from deep power-down (RDP) instruction, while an erase, program or write
cycle is in progress, is rejected without having any effects on the cycle that is in progress.
Figure 17. Release from deep power-down (RDP) instruction sequence
S
C
D
Q
High Impedance
0
1
2
Instruction
3
4
5
6
Figure
7
17.
Deep power-down mode
t
RDP
RDP
, the device is put in the
Standby mode
Instructions
AI06807
31/47