TB6584AFNG(O,EL) Toshiba, TB6584AFNG(O,EL) Datasheet - Page 26

• Manufacturer Part Number: TB6584AFNG(O,EL)
• Description: Motor / Motion / Ignition Controllers & Drivers 3-Phase Brushless Driver IC 45V 1.8A
• Manufacturer: Toshiba

Specifications of TB6584AFNG(O,EL)

• Product Category: Motor / Motion / Ignition Controllers & Drivers
• Rohs: yes

IC Usage Considerations
Points to Remember on Handling of ICs
Notes on handling of ICs
(1)
(2)
(3)
(4)
(1)
(2)
(3)
The absolute maximum ratings of a semiconductor device are a set of ratings that must not be
exceeded, even for a moment. Do not exceed any of these ratings.
Exceeding the rating(s) may cause the device breakdown, damage or deterioration, and may result
injury by explosion or combustion.
Use an appropriate power supply fuse to ensure that a large current does not continuously flow in case
of over current and/or IC failure. The IC will fully break down when used under conditions that exceed
its absolute maximum ratings, when the wiring is routed improperly or when an abnormal pulse noise
occurs from the wiring or load, causing a large current to continuously flow and the breakdown can
lead smoke or ignition. To minimize the effects of the flow of a large current in case of breakdown,
appropriate settings, such as fuse capacity, fusing time and insertion circuit location, are required.
If your design includes an inductive load such as a motor coil, incorporate a protection circuit into the
design to prevent device malfunction or breakdown caused by the current resulting from the inrush
current at power ON or the negative current resulting from the back electromotive force at power OFF.
IC breakdown may cause injury, smoke or ignition.
Use a stable power supply with ICs with built-in protection functions. If the power supply is unstable,
the protection function may not operate, causing IC breakdown. IC breakdown may cause injury,
smoke or ignition.
Do not insert devices in the wrong orientation or incorrectly.
Make sure that the positive and negative terminals of power supplies are connected properly.
Otherwise, the current or power consumption may exceed the absolute maximum rating, and
exceeding the rating(s) may cause the device breakdown, damage or deterioration, and may result
injury by explosion or combustion.
In addition, do not use any device that is applied the current with inserting in the wrong orientation or
incorrectly even just one time.
Over current protection circuit
Over current protection circuits (referred to as current limiter circuits) do not necessarily protect ICs
under all circumstances. If the Over current protection circuits operate against the over current, clear
the over current status immediately.
Depending on the method of use and usage conditions, such as exceeding absolute maximum ratings
can cause the over current protection circuit to not operate properly or IC breakdown before operation.
In addition, depending on the method of use and usage conditions, if over current continues to flow for
a long time after operation, the IC may generate heat resulting in breakdown.
Heat radiation design
In using an IC with large current flow such as power amp, regulator or driver, please design the device
so that heat is appropriately radiated, not to exceed the specified junction temperature (TJ) at any
time and condition. These ICs generate heat even during normal use. An inadequate IC heat radiation
design can lead to decrease in IC life, deterioration of IC characteristics or IC breakdown. In addition,
please design the device taking into considerate the effect of IC heat radiation with peripheral
components.
Back-EMF
When a motor rotates in the reverse direction, stops or slows down abruptly, a current flow back to the
motor’s power supply due to the effect of back-EMF. If the current sink capability of the power supply
is small, the device’s motor power supply and output pins might be exposed to conditions beyond
maximum ratings. To avoid this problem, take the effect of back-EMF into consideration in system
design.
26
TB6584AFNG
2010-05-27