ZLED7015ZI1R ZMDI, ZLED7015ZI1R Datasheet - Page 19

• Manufacturer Part Number: ZLED7015ZI1R
• Description: LED Lighting Drivers LED driver
• Manufacturer: ZMDI

Specifications of ZLED7015ZI1R

• Rohs: yes
• Input Voltage: 6 V to 30 V
• Maximum Supply Current: 2 mA
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: MSOP-10
• Minimum Operating Temperature: - 40 C

5
All high voltage pins (1, 4, 5, 9, and 10) have an ESD protection of >± 2500V according to the Human Body
Model (HBM). The ESD test follows the Human Body Model based on MIL 883-H, Method 3015.8
All low voltage pins (2, 3, 6, 7, and 8) have an ESD protection of >± 4000V according to the Human Body
Model (HBM). The ESD test follows the Human Body Model based on MIL 883-H, Method 3015.8
All pins pass the latch-up test based on the JEDEC Standard No. 78B, December 2008.
6
The ZLED7015 package is an MSOP-10, which has a thermal resistance (junction to ambient) of
R
Figure 6.1
Table 6.1
Data Sheet
December 20, 2011
Pin Name
Thermal
θJA
PGND
AGND
AGND
ZLED7015
1.0MHz Boost Converter with Internal 35V Switch
OVP
VDD
Pad
n.c.
EN
VP
FB
LX
= 60°C/W.
ESD/Latch-Up-Protection
Pin Configuration and Package
ZLED7015 Pin Configuration—MSOP-10 Package
Pin Description MSOP-10
No.
10
1
2
3
4
5
6
7
8
9
© 2011 Zentrum Mikroelektronik Dresden AG — Rev. 1.00
All rights reserved. The material contained herein may not be reproduced, adapted, merged, translated, stored, or used without
the prior written consent of the copyright owner. The information furnished in this publication is subject to changes without notice.
Power ground
Internal 5V linear regulator output. VP is the power supply for the internal switch gate driver and the
internal control circuitry. Use a 10µF ceramic bypass capacitor between VP and ground.
Analog (signal) ground.
Enable control input. Important: Do not allow this pin to float.
Analog (signal) ground.
Over-voltage protection control input.
Feedback voltage input. The nominal average output current is set by the value of R
FB to GND – see section 2.2.1 for details. Important: Do not allow the FB pin to float.
No connection
Supply voltage (6V to 30V)—see section 7 for layout considerations.
Drain of the internal switch. Connect the power inductor between LX and the power supply. Connect the
output rectifier D
Connect to ground.
1
between LX and the output circuit. See section1.1 for output range specifications.
PGND
AGND
AGND
EN
VP
Description
LX
VDD
NC
FB
OVP
S
connected from
19 of 22