SLATA512MM1UI STEC, SLATA512MM1UI Datasheet - Page 30

• Manufacturer Part Number: SLATA512MM1UI
• Description: Memory Cards 512Mb 3.3-5V Ind Temp
• Manufacturer: STEC

Specifications of SLATA512MM1UI

• Product Category: Memory Cards
• Rohs: yes
• Product: PC Cards
• Memory Size: 512 MB
• Sustained Read: 10 MB/s
• Sustained Write: 7 MB/s
• Active Mode Current: 75 mA
• Operating Supply Voltage: 3.3 V, 5 V
• Maximum Operating Temperature: + 85 C
• Dimensions: 85.6 mm x 54 mm x 5 mm
• Connector Type: 68 Pin Female
• Minimum Operating Temperature: - 40 C

SLATAxxx(M/G)M1U(I)
Datasheet
5.0 Registers
This chapter lists the registers of the ATA PC Card. Refer to ATA PC Card standards for further details.
5.1
In PC Card Mode, four configuration registers, as listed in Table 22, are used.
Note: In True IDE Mode, these registers cannot be used.
Configuration Option Register
Configuration and Status Register
Pin Replacement Register
Socket and Copy Register.
Configuration Registers
Configuration Register
Table 22: Configuration Registers
This register is used to configure and observe the status of the ATA PC
Card, and to issue soft resets to it. Also, the Index bits of this register are
used to select the PC Card mapping mode that the ATA PC Card uses: 1)
PC Card Memory, 2) PC Card Contiguous I/O, 3).PC Card Primary I/O,
and 4) PC Card Secondary I/O
This register is used for observing the ATA PC Card state.
This register is used for providing the signal state of -IREQ when the ATA
PC Card is configured in the PC Card I/O Mode.
This read/write register is used to identify the ATA PC Card from other
devices. This register should be set by the host before this Configuration
Option register is set.
61000-04497-117, April 2008
Description
ATA PC Card
30