STM8AF628ATCY STMicroelectronics, STM8AF628ATCY Datasheet - Page 84

• Manufacturer Part Number: STM8AF628ATCY
• Description: 8-bit Microcontrollers - MCU 8-Bit Automotive MCU EEPROM 128kb Flash
• Manufacturer: STMicroelectronics

Specifications of STM8AF628ATCY

• Product Category: 8-bit Microcontrollers - MCU
• Rohs: yes
• Core: STM8A
• Data Bus Width: 8 bit

Electrical characteristics
10.3.12
84/110
EMC characteristics
Susceptibility tests are performed on a sample basis during product characterization.
Functional EMS (electromagnetic susceptibility)
While executing a simple application (toggling 2 LEDs through I/O ports), the product is
stressed by two electromagnetic events until a failure occurs (indicated by the LEDs).
●
●
A device reset allows normal operations to be resumed. The test results are given in the
table below based on the EMS levels and classes defined in application note AN1709.
Designing hardened software to avoid noise problems
EMC characterization and optimization are performed at component level with a typical
application environment and simplified MCU software. It should be noted that good EMC
performance is highly dependent on the user application and the software in particular.
Therefore it is recommended that the user applies EMC software optimization and
prequalification tests in relation with the EMC level requested for his application.
Software recommendations
The software flowchart must include the management of runaway conditions such as:
●
●
●
Prequalification trials
Most of the common failures (unexpected reset and program counter corruption) can be
recovered by applying a low state on the NRST pin or the oscillator pins for 1 second.
To complete these trials, ESD stress can be applied directly on the device, over the range of
specification values. When unexpected behavior is detected, the software can be hardened
to prevent unrecoverable errors occurring (see application note AN1015).
Table 47.
Symbol
V
V
FESD
EFTB
ESD: Electrostatic discharge (positive and negative) is applied on all pins of the device
until a functional disturbance occurs. This test conforms with the IEC 1000-4-2
standard.
FTB: A burst of fast transient voltage (positive and negative) is applied to V
through a 100 pF capacitor, until a functional disturbance occurs. This test conforms
with the IEC 1000-4-4 standard.
Corrupted program counter
Unexpected reset
Critical data corruption (control registers...)
Voltage limits to be applied on any I/O pin
to induce a functional disturbance
Fast transient voltage burst limits to be
applied through 100 pF on V
pins to induce a functional disturbance
EMS data
Parameter
Doc ID 14395 Rev 9
DD
and V
SS
f
f
MASTER
MASTER
Conforms to IEC 1000-4-2
Conforms to IEC 1000-4-4
V
V
DD
DD
STM8AF52/62xx, STM8AF51/61xx
= 3.3 V, T
= 3.3 V, T
= 16 MHz (HSI clock),
= 16 MHz (HSI clock),
Conditions
A
A
= 25 °C,
= 25 °C,
DD
Level/class
and V
3B
4A
SS