MAX7438ETP-T Maxim Integrated, MAX7438ETP-T Datasheet - Page 10

• Manufacturer Part Number: MAX7438ETP-T
• Description: Active Filter
• Manufacturer: Maxim Integrated

Specifications of MAX7438ETP-T

• Number Of Channels: 3
• Maximum Operating Temperature: + 85 C
• Package / Case: TQFN EP-20
• Minimum Operating Temperature: - 40 C

Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are
implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.
10 ____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600
© 2003 Maxim Integrated Products
(The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information,
go to www.maxim-ic.com/packages.)
Triple-Channel Video Reconstruction Filters with
Back-Porch Clamp to GND
NOTES:
10. WARPAGE SHALL NOT EXCEED 0.10 mm.
1. DIMENSIONING & TOLERANCING CONFORM TO ASME Y14.5M-1994.
2. ALL DIMENSIONS ARE IN MILLIMETERS. ANGLES ARE IN DEGREES.
3. N IS THE TOTAL NUMBER OF TERMINALS.
4. THE TERMINAL #1 IDENTIFIER AND TERMINAL NUMBERING CONVENTION SHALL CONFORM TO JESD 95-1
5. DIMENSION b APPLIES TO METALLIZED TERMINAL AND IS MEASURED BETWEEN 0.25 mm AND 0.30 mm
6. ND AND NE REFER TO THE NUMBER OF TERMINALS ON EACH D AND E SIDE RESPECTIVELY.
7. DEPOPULATION IS POSSIBLE IN A SYMMETRICAL FASHION.
8. COPLANARITY APPLIES TO THE EXPOSED HEAT SINK SLUG AS WELL AS THE TERMINALS.
9. DRAWING CONFORMS TO JEDEC MO220.
PIN # 1
I.D.
SPP-012. DETAILS OF TERMINAL #1 IDENTIFIER ARE OPTIONAL, BUT MUST BE LOCATED WITHIN THE
ZONE INDICATED. THE TERMINAL #1 IDENTIFIER MAY BE EITHER A MOLD OR MARKED FEATURE.
FROM TERMINAL TIP.
C
D
Printed USA
D/2
COMMON DIMENSIONS
A1 A3
E/2
0.15 C A
E
A
0.15 C B
0.10 C
0.08 C
(NE-1) X e
DETAIL A
L
is a registered trademark of Maxim Integrated Products.
k
C L
e
TITLE:
TITLE:
APPROVAL
APPROVAL
(ND-1) X e
PROPRIETARY INFORMATION
PROPRIETARY INFORMATION
PACKAGE OUTLINE
16, 20, 28, 32L, QFN THIN, 5x5x0.8 mm
PACKAGE OUTLINE
16, 20, 28, 32L, QFN THIN, 5x5x0.8 mm
e
D2
L C
EXPOSED PAD VARIATIONS
D2/2
DOCUMENT CONTROL NO.
DOCUMENT CONTROL NO.
b
21-0140
21-0140
L
E2/2
0.10 M C A B
Package Information
0.35x45
PIN # 1 I.D.
k
L C
e
E2
L C
REV.
REV.
C
C
L
2
1
2
2