M24256-BFMB6TG STMicroelectronics, M24256-BFMB6TG Datasheet - Page 17
![no-image](/images/manufacturer_photos/0/6/637/stmicroelectronics_sml.jpg)
M24256-BFMB6TG
Manufacturer Part Number
M24256-BFMB6TG
Description
EEPROM 256 Kbit EEPROM Three Chip Enable
Manufacturer
STMicroelectronics
Datasheet
1.M24256-DRMN6TP.pdf
(40 pages)
Specifications of M24256-BFMB6TG
Product Category
EEPROM
Rohs
yes
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
M24256-BFMB6TG
Manufacturer:
STM
Quantity:
5 500
M24256-BW M24256-BR M24256-BF M24256-DR M24256-DF
5.1.3
5.1.4
5.1.5
Write Identification Page (M24256-D only)
The Identification Page (64 bytes) is an additional page which can be written and (later)
permanently locked in Read-only mode. It is written by issuing the Write Identification Page
instruction. This instruction uses the same protocol and format as Page Write (into memory
array), except for the following differences:
●
●
If the Identification page is locked, the data bytes transferred during the Write Identification
Page instruction are not acknowledged (NoAck).
Lock Identification Page (M24256-D only)
The Lock Identification Page instruction (Lock ID) permanently locks the Identification page
in Read-only mode. The Lock ID instruction is similar to Byte Write (into memory array) with
the following specific conditions:
●
●
●
ECC (Error Correction Code) and Write cycling
The Error Correction Code (ECC) is an internal logic function which is transparent for the
I
The ECC logic is implemented on each group of four EEPROM bytes
single bit out of the four bytes happens to be erroneous during a Read operation, the ECC
detects this bit and replaces it with the correct value. The read reliability is therefore much
improved.
Even if the ECC function is performed on groups of four bytes, a single byte can be
written/cycled independently. In this case, the ECC function also writes/cycles the three
other bytes located in the same group
defined at group level and the cycling can be distributed over the 4 bytes of the group: the
sum of the cycles seen by byte0, byte1, byte2 and byte3 of the same group must remain
below the maximum value defined
1. A group of four bytes is located at addresses [4*N, 4*N+1, 4*N+2, 4*N+3], where N is an
2
C communication protocol.
integer.
Device type identifier = 1011b
MSB address bits A15/A6 are don't care except for address bit A10 which must be ‘0’.
LSB address bits A5/A0 define the byte address inside the Identification page.
Device type identifier = 1011b
Address bit A10 must be ‘1’; all other address bits are don't care
The data byte must be equal to the binary value xxxx xx1x, where x is don't care
Doc ID 6757 Rev 30
Table 11: Cycling performance by groups of four
(1)
. As a consequence, the maximum cycling budget is
(1)
. Inside a group, if a
Instructions
bytes.
17/40