DS1088LU-66/T Maxim Integrated, DS1088LU-66/T Datasheet - Page 6

• Manufacturer Part Number: DS1088LU-66/T
• Description: Programmable Oscillators
• Manufacturer: Maxim Integrated
• Series: DS1088r

Specifications of DS1088LU-66/T

• Part # Aliases: 90-1L88P-066

Figure 1. Block Diagram
Maxim Integrated
The DS1088L is a low-cost clock generator that pro-
duces a square-wave output without external timing com-
ponents. The fixed-frequency oscillator is available in
factory-calibrated frequencies from 312kHz to 133MHz.
The device has a power-down pin for power-sensitive
applications. A block diagram is shown in
The internal oscillator frequency is divided by the factory-
programmed prescaler to produce an output frequency
of 312kHz to 133MHz. Contact the factory for custom
frequencies.
The PDN pin disables the internal oscillator and the
oscillator output for power-sensitive applications. The
power-down pin must remain low for at least two output
frequency cycles plus 10µs for deglitching purposes. On
power-up, the output is disabled until power is stable
and the voltage-controlled oscillator has generated 512
clock cycles.
GND
PDN
V
CC
V
CC
CONTROL
EEPROM
80MHz TO 160MHz
CONTROLLED
OSCILLATOR
VOLTAGE-
Detailed Description
÷ BY 1, 2, 4...256
DS1088L
PRESCALER
Power-Down Mode
Output Frequency
Fixed-Frequency EconOscillator™
Figure
OUT
(312kHz
TO 133MHz)
1.
To achieve the best results when using the DS1088L,
the power supply must be decoupled with 0.01µF and
0.1µF high-quality, ceramic, surface-mount capacitors.
Surface-mount components minimize lead inductance,
which improves performance, and tend to have ade-
quate high-frequency response for decoupling applica-
tions. These capacitors should be placed as close as
possible to the V
SUBSTRATE CONNECTED TO GROUND
CC
Applications Information
and GND pins.
Power-Supply Decoupling
Chip Information
DS1088L
6