S9S12P32J0VFTR Freescale Semiconductor, S9S12P32J0VFTR Datasheet - Page 518

• Manufacturer Part Number: S9S12P32J0VFTR
• Description: 16-bit Microcontrollers - MCU 16 BIT 32K FLASH
• Manufacturer: Freescale Semiconductor

Specifications of S9S12P32J0VFTR

• Rohs: yes
• Core: S12
• Processor Series: MC9S12P
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 16 MHz
• Program Memory Size: 32 KB
• Data Ram Size: 2 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 3.15 V to 5.5 V
• Operating Temperature Range: - 40 C to + 105 C
• Package / Case: QFN-48
• Mounting Style: SMD/SMT

Electrical Characteristics
A.3
A.3.1
The time base for all NVM program or erase operations is derived from the bus clock using the FCLKDIV
register. The frequency of this derived clock must be set within the limits specified as f
module does not have any means to monitor the frequency and will not prevent program or erase operation
at frequencies above or below the specified minimum. When attempting to program or erase the NVM
module at a lower frequency, a full program or erase transition is not assured.
The following sections provide equations which can be used to determine the time required to execute
specific flash commands. All timing parameters are a function of the bus clock frequency, f
program and erase times are also a function of the NVM operating frequency, f
timing parameters can be found in
A.3.1.1
The time required to perform a blank check on all blocks is dependent on the location of the first non-blank
word starting at relative address zero. It takes one bus cycle per phrase to verify plus a setup of the
command. Assuming that no non-blank location is found, then the time to erase verify all blocks is given
by:
A.3.1.2
The time required to perform a blank check is dependent on the location of the first non-blank word starting
at relative address zero. It takes one bus cycle per phrase to verify plus a setup of the command.
Assuming that no non-blank location is found, then the time to erase verify a P-Flash block is given by:
Assuming that no non-blank location is found, then the time to erase verify a D-Flash block is given by:
518
t
t
t
check
dcheck
pcheck
NVM
=
=
=
Timing Parameters
35500
2800
Erase Verify All Blocks (Blank Check) (FCMD=0x01)
Erase Verify Block (Blank Check) (FCMD=0x02)
33500
⋅
⋅
⋅
-------------------- -
f
-------------------- -
f
NVMBUS
NVMBUS
-------------------- -
f
NVMBUS
1
1
1
S12P-Family Reference Manual, Rev. 1.13
Table
A-18.
NVMOP
Freescale Semiconductor
. A summary of key
NVMOP
NVMBUS
. The NVM
. All