IR1000-01B SMC, IR1000-01B Datasheet - Page 14

• Manufacturer Part Number: IR1000-01B
• Description: PRECISION REGULATOR, 1/8"; SVHC 2: Bis (2-ethyl(hexyl)phthalate) (DEHP); SVHC (Additional): Dibutyl phthalate (DBP)
• Manufacturer: SMC

2. Do not allow twisting or bending moment to
3. Since excessive moment loads and the
1. Screw piping together with the recommended
1.6-14
Connection thread
Torque
be applied other than the weight of the
equipment itself.
Provide separate support for external piping, as damage may
otherwise occur.
propagation of vibrations, etc. can easily
result from inflexible piping made of steel,
etc., avoid these problems by using flexible
tubing for intermediate connections.
proper torque while holding the side with
female threads.
Looseness or faulty sealing will occur if tightening torque is
insufficient, while thread damage will result if the torque is
excessive. Furthermore, if the side with the female threads is
not held while tightening, excessive force will be applied directly
to piping brackets, etc. causing damage or other problems.
Warning
Series
Precision Regulator Precautions
Be sure to read before handling.
Refer to p.0-26 and 0-27 for Safety Instructions and common precautions on the products
mentioned in this catalogue.
7 to 9
1/8
Piping
12 to 14
1/4
IR1000/2000/3000
Recommended proper torque Nm
22 to 24
3/8
28 to 30
1/2
1. Do not operate in locations having an
2. Do not operate in locations where vibration or
3. In locations which receive direct sunlight,
4. In locations near heat sources, block off any
5. In locations where there is contact with
1. These products are designed for use with
2. Do not use compressed air which includes
3. If drainage is not removed from air filters and
1. Preparation before piping
2. Wrapping of pipe tape
atmosphere of corrosive gases, chemicals,
sea water, water or steam, or where there will
be contact with the same.
impact occurs.
provide a protective cover, etc.
radiated heat.
spatter from water, oil or solder, etc.,
implement suitable protective measures.
compressed air. Contact SMC if any other
fluid will be used.
chemicals, synthetic oils containing organic
solvents, salt, or corrosive gases, etc., as this
can cause damage or malfunction.
mist separators, it can flow out to the
downstream side and lead to the malfunction
of pneumatic equipment.
In cases where the management of drainage
removal will be difficult, the use of filters with
auto drains is recommended.
Before piping is connected, it should be thoroughly blown out
with air (flushing) or washed to remove cutting chips, cutting
oil and other debris from inside the pipe.
When connecting pipes and fittings, etc., be sure that cutting
chips from the pipe threads and sealing material do not get
inside.
Further, when pipe tape is used, leave 1.5 to 2 thread ridges
exposed at the end of the pipe/fitting.
Warning
Warning
Caution
Operating Environment
Air Supply
Piping
Winding
direction
Pipe tape