ACPM-7821-TR1 AVAGO [AVAGO TECHNOLOGIES LIMITED], ACPM-7821-TR1 Datasheet - Page 13

• Manufacturer Part Number: ACPM-7821-TR1
• Description: 4 x 4 Power Amplifier Module for J-CDMA (898 - 925 MHz)
• Manufacturer: AVAGO [AVAGO TECHNOLOGIES LIMITED]

13
Handling and Storage
ESD (Electrostatic Discharge)
Electrostatic discharge occurs naturally in the envi-
ronment. With the increase in voltage potential, the
outlet of neutralization or discharge will be sought. If
the acquired discharge route is through a semicon-
ductor device, destructive damage will result. ESD
countermeasure methods should be developed and
used to control potential ESD damage during handling
in a factory environment at each manufacturing site.
MSL (Moisture Sensitivity Level)
Plastic encapsulated surface mount package is sen-
sitive to damage induced by absorbed moisture and
temperature. Avago follows JEDEC Standard J-STD
020A. Each component and package type is classi-
fied for moisture sensitivity by soaking a known dry
Table 5. ESD Classification
Pin#
All Pins
Note:
1. PA module products should be considered extremely ESD sensitive.
Table 6. Moisture Classification Level and Floor Life
MSL Level
1
2
2a
3
4
5
5a
6
Note:
1. The MSL Level is marked on the MSL Label on each shipping bag.
±1000V
Rating
Floor Life (out of bag) at factory ambient ≤ 30°C/60% RH or as stated
Unlimited at ≤ 30
1 year
4 weeks
168 hours
72 hours
48 hours
24 hours
Mandatory bake before use. After bake, must be reflowed within the time limit specified on the label
HBM
(JESD22-A115-A)
Class 1C
o
C/85% RH
Class
Rating
± 200V
package at various temperatures and relative humid-
ity, and times. After soak, the components are sub-
jected to three consecutive simulated reflows.
The out of bag exposure time maximum limits are
determined by the classification test describe
above which corresponds to an MSL classification
level 6 to 1 according to the JEDEC standard
IPC/JEDEC J-STD-020A and J-STD-033.
ACPM-7821 is MSL3. Thus, according to the J-STD-
033 p.11 the maximum Manufacturers Exposure Time
(MET) for this part is 168 hours. After this time
period, the part would need to be removed from the
reel, de-taped and then re-bake.
MSL classification ref low temperature for the
ACPM-7821 is targeted at 250° C +0/-5° C. Figure 19
and Table 7 show typical SMT profile for maximum
temperature of 250° C +0/-5° C.
MM
Class B
Class
Rating
± 200V
CDM
(JESD22-C101C)
Class II
Class