SFSH3.58MCB YAMAR [Yamar Electronics Ltd.], SFSH3.58MCB Datasheet - Page 6

• Manufacturer Part Number: SFSH3.58MCB
• Description: for DC-LIN Asynchronous Communication Over Noisy Lines
• Manufacturer: YAMAR [Yamar Electronics Ltd.]

@ 2007 Yamar Electronics Ltd.
The device is designed for operation in two selectable carrier frequencies (channels).
Presence of an interference signal can be read from the device internal register.
Bit 0 in control register 0 determines the operating channel F1 or F0.
When high, the device switches its channel automatically whenever an interference signal is detected in
the operating frequency. If the device did not receive any data in the new channel it will return to the
previous channel after 2Sec. if, again, no data has been received for 2Sec. and the interference has
stopped, it will switch frequency once more and will stay at the new channel.
Output signal indicates the selected channel. F0=”High”, F1= “Low”.
The SIG40 is designed to operate with a low cost 32.768KHz crystal connected between OscIn and
OscOut pins. This type of crystal has the advantage of very low power consumption and low cost.
However there are also drawbacks. It is very sensitive to noise and has a temperature dependency that
should be carefully considered when selecting the crystal.
The following guidelines should be used when designing the PCB:
The values of C1, C2 in Figure 3.3 oscillator circuitry should be determined according to the crystal
manufacturer recommendations.
The overall frequency tolerance should not exceed 200ppm.
VccPLL should be connected to Vcc. GndPLL should be connected to ground. The PLL supply has to
be sufficiently powered, to avoid any fluctuations of power supply. A capacitor of at least 47uF should
be connected as close as possible to these pins. It is recommended to keep the lines between 3.3V
power supply and the Vcc pins as short as possible with wide PCB traces.
3.4.1
3.4.2
3.4.3
3.5.1
3.4
3.5
3.6
1. Design the trace length as short as possible.
2. Avoid thin line on resonator traces (< 0.010"), keep them as wide as possible.
3. To avoid noise, protect these signals with Ground shields.
Frequency Control
Crystal Oscillator
PLL Power Pins
Operating Frequency
InterfHop
MF0nF1
Recommended 32.768KHz Crystal Specifications
Nominal Frequency:
Frequency tolerance @25ºC
Load capacitance
Serial resistance
Drive level
Quality factor
Turnover temperature
Parabolic constant
Aging
Operating temperature
Storage temperature
Proprietary and Confidential Information of YAMAR Electronics Ltd.
Type
6
32.768KHz
+/-20 ppm
12.5 pF
50K Ohm (max.)
1uW (max.)
50,000 (max.)
+25ºC +/- 5ºC
-0.04 ppm/ºC² (max.)
+/-3 ppm in first year (max.)
-40ºC to + 85ºC
-55ºC to + 125ºC
Value
DS-SIG40 R1.8