DMC16230H OPTREX [OPTREX CORPORATION], DMC16230H Datasheet - Page 9

• Manufacturer Part Number: DMC16230H
• Description: CD Module Specification
• Manufacturer: OPTREX [OPTREX CORPORATION]

Note 1 : Unless otherwise specified, tests will be conducted under the following condition.
Note 2 : Unless otherwise specified, tests will be not conducted under functioning state.
Note 3 : No dew condensation to be observed.
Note 4 : The function test shall be conducted after 4 hours storage at the normal temperature and humidity
Note 5 : Vibration test will be conducted to the product itself without putting it in a container.
No.
5.Test
1
2
3
4
5
6
7
DMC16230H (AF) No.2000-0208
No change on display and in operation under the following test condition.
after removed from the test chamber.
High Temperature Operating
Low Temperature Operating
High Temperature Storage
Low Temperature Storage
Damp Proof Test
Vibration Test
Shock Test
Temperature : 20±5℃
Humidity
Parameter
: 65±5%
70℃±2℃, 96hrs (operation state)
-20℃±2℃, 96hrs (operation state)
80℃±2℃, 96hrs
-30℃±2℃, 96hrs
60℃±2℃, 85～90%RH, 96hrs
Total fixed amplitude : 1.5mm
Vibration Frequency : 10～55Hz
One cycle 60 seconds to 3 directions of X, Y, Z for
each 15 minutes
To be measured after dropping from 60cm high on
the concrete surface in packing state.
E
B
OPTREX
60cm
G
Concrete Surface
OPTREX CORPORATION
D
A
Conditions
C
F
Dropping method corner dropping
Edge dropping
Face dropping
A corner : once
B,C,D edge : once
E,F,G face : once
Page 9/15
Notes
3, 4
3, 4
3
4
5