SLIN-03E1A0 BEL [Bel Fuse Inc.], SLIN-03E1A0 Datasheet - Page 19

no-image

SLIN-03E1A0

Manufacturer Part Number
SLIN-03E1A0
Description
NON-ISOLATED DC/DC CONVERTERS 4.5 Vdc - 14 Vdc Input, 0.59 Vdc - 5.5 Vdc /3 A Outputs
Manufacturer
BEL [Bel Fuse Inc.]
Datasheet
Power Good
The SLIN-03E1Ax modules provide a Power Good (PGOOD) signal that is implemented with an open-drain
output to indicate that the output voltage is within the regulation limits of the power module. The PGOOD signal
will be de-asserted to a low state if any condition such as over temperature, over current or loss of regulation
occurs that would result in the output voltage going ±10% outside the set-point value. The PGOOD terminal
should be connected through a pull-up resistor (suggested value 100KΩ) to a source of 5VDC or lower.
Tunable Loop
The SLIN-03E1Ax modules have a new feature that optimizes transient response of the module called Tunable
Loop
External capacitors are usually added to the output of the module for two reasons: to reduce output ripple and
noise and to reduce output voltage deviations from the steady-state value in the presence of dynamic load
current changes. Adding external capacitance however affects the voltage control loop of the module, typically
causing the loop to slow down with sluggish response. Larger values of external capacitance could also cause
the module to become unstable.
The Tunable Loop
connected to the output of the module. The Tunable Loop
between the SENSE and TRIM pins of the module, as shown below. This R-C allows the user to externally
adjust the voltage loop feedback compensation of the module.
Recommended values of R
2 and 3. Table 2 shows the recommended values of R
capacitors up to 470uF that might be needed for an application to meet output ripple and noise requirements.
Selecting R
In applications with tight output voltage limits in the presence of dynamic current loading, additional output
capacitance will be required. Table 3 lists recommended values of R
voltage deviation limits for some common output voltages in the presence of a 1.5A to 3A step change (50% of
full load), with an input voltage of 12V.
October 8, 2009
NON-ISOLATED DC/DC CONVERTERS
4.5 Vdc - 14 Vdc Input, 0.59 Vdc - 5.5 Vdc /3 A Outputs
TM
.
Circuit diagram showing connection of R
TUNE
Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel 201-432-0463 • Fax 201-432-9542 •
and C
TM
TM
allows the user to externally adjust the voltage control loop to match the filter network
TUNE
according to Table 2 will ensure stable operation of the module.
TUNE
and C
TUNE
MODULE
GND
for different output capacitor combinations are given in below Tables
SENSE
VOUT
Bel Power, Inc. , a subsidiary of Bel Fuse, Inc.
TRIM
TUNE
and C
TUNE
TUNE
RTUNE
CTUNE
RTrim
TM
and C
to tune the control loop of the module
is implemented by connecting a series R-C
TUNE
C O
TUNE
for different values of ceramic output
and C
TUNE
in order to meet 2% output
www.belfuse.com
19

Related parts for SLIN-03E1A0