FTR-C1SA012G FUJITSU [Fujitsu Component Limited.], FTR-C1SA012G Datasheet - Page 8

• Manufacturer Part Number: FTR-C1SA012G
• Description: POWER RELAY 2 POLES-2A High Insulation/wide Gap
• Manufacturer: FUJITSU [Fujitsu Component Limited.]

RoHS Compliance and Lead Free Information
1. General Information
l
l
l
l
l
2. Recommended Lead Free Solder Profile
l
3. Moisture Sensitivity
l
4. Tin Whiskers
l
All signal and power relays produced by Fujitsu Components are compliant with RoHS directive 2002/95EC
Cadmium as used in electrical contacts is exempted from the RoHS directives on October 21st, 2005.
All of our signal and power relays are lead-free. Please refer to Lead-Free Status Info for older date codes
Lead free solder plating on relay terminals is Sn-3.0Ag-0.5Cu, unless otherwise specified.
“LF” is marked on each outer and inner carton. (No marking on individual relays).
Recommended solder Sn-3.0Ag-0.5Cu.
Moisture Sensitivity Level standard is not applicable to electromechanical relays, unless otherwise indicated.
Dipped SnAgCu solder is known as presenting a low risk to tin whisker development. No considerable length
Flow Solder condition:
Pre-heating:
Soldering:
Solder by Soldering Iron:
Soldering Iron
Temperature: maximum 360˚C
Duration:
We highly recommend that you confirm your actual solder conditions
(Amendment to Directive 2002/95/EC)
This material has been verified to be compatible with PbSn assembly process.
whisker was found by our in house test.
at: http://www.fujitsu.com/us/downloads/MICRO/fcai/relays/lead-free-letter.pdf
including amendments.
maximum 120˚C
dip within 5 sec. at
260˚C solder bath
maximum 3 sec.
FTR-C1 SERIES
FTR-K1 SERIES
8