AT17C010-10 ATMEL Corporation, AT17C010-10 Datasheet - Page 2
![no-image](/images/manufacturer_photos/0/0/79/atmel_corporation_sml.jpg)
AT17C010-10
Manufacturer Part Number
AT17C010-10
Description
FPGA Configuration E2PROM Memory
Manufacturer
ATMEL Corporation
Datasheet
1.AT17C010-10.pdf
(9 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
AT17C010-10JC
Manufacturer:
AT
Quantity:
20 000
Controlling The High-Density AT17 Series Serial EEPROMs
Most connections between the FPGA device and the Serial
EEPROM are simple and self-explanatory:
• The DATA output of the high-density AT17 Series drives
• The master FPGA CCLK output drives the CLK input of
• The CEO output of any AT17C/LV512/010 drives the CE
• SER_EN must be connected to V
READY is available as an open-collector indicator of the
device’s RESET status; it is driven Low while the device is
in its POWER-ON RESET cycle and released (tri-stated)
when the cycle is complete.
There are two different ways to use the inputs CE and OE,
as shown in the AC Characteristics waveforms.
Condition 1
The simplest connection is to have the FPGA D/P output
drive both CE and RESET/OE in parallel (Figure 1). Due to
Block Diagram
2
DIN of the FPGA devices.
the high-density AT17 Series.
input of the next AT17C/LV512/010 in a cascade chain of
PROMs.
ISP).
AT17C/LV512/010
CC
, (except during
its simplicity, however, this method will fail if the FPGA
receives an external reset condition during the configura-
tion cycle. If a system reset is applied to the FPGA, it will
abort the original configuration and then reset itself for a
new configuration, as intended. Of course, the high-density
AT17 Series does not see the external reset signal and will
not reset its internal address counters and, consequently,
will remain out of sync with the FPGA for the remainder of
the configuration cycle.
Condition 2
The FPGA D/P output drives only the CE input of the high-
density AT17 Series, while its OE input is driven by the
inversion of the input to the FPGA RESET input pin. This
connection works under all normal circumstances, even
when the user aborts a configuration before D/P has gone
High. A High lev el on the RES ET/OE inpu t to the
AT17C/LVxxx – during FPGA reset – clears the Configura-
tor’s internal address pointer, so that the reconfiguration
starts at the beginning. The high-density AT17 Series does
not require an inverter since the RESET polarity is pro-
grammable.