LMC1983 National Semiconductor, LMC1983 Datasheet - Page 12

• Manufacturer Part Number: LMC1983
• Description: Digitally-Controlled Stereo Tone and Volume Circuit with Three Selectable Stereo Inputs
• Manufacturer: National Semiconductor

www.national.com
Application Information
no affect on a respective control. They are necessary to
properly position the data in the LMC1983’s internal data
shift register. Unexpected results may take place if these bits
are not sent.
The LMC1983’s internal data shift register can handle either
a 16-bit word or two 8-bit serial data transmissions. It is the
final 8 bits of data received before the ID line goes high that
are used as the LMC1983 selection and function addresses.
The final eight bits after the ID line returns high are used to
change a function’s operating point. CLK must be stopped
when the final 8 data bits are received. The data stored in the
internal data latch remains unchanged until the ID is pulsed,
signifying the end of data transmission. When ID is pulsed,
the new data in the data shift register is latched into the data
latch and the selected function takes on a new operating
point.
A complete description and more information concerning the
IM Bus is given in the appendix of ITT’s CCU2000
datasheet.
(Continued)
12
DIGITAL I/O
The LMC1983’s two Digital Input pins, 2 and 3, provide
single-bit communication between a peripheral device and
the controller over the IM Bus. Each pin has an internal
30 k
nected to open collector/drain outputs. The type of informa-
tion that could be received on these lines and retrieved by a
controller include FM stereo pilot indication, power on/off,
Secondary Audio Program (SAP), etc.
According to Table 1 , the logic state of DIGITAL INPUT 1 and
DIGITAL INPUT 2 is latched and can be retrieved over the IM
Bus using the read command (47
tion sent on the IM Bus is active low since these lines are in-
ternally pulled high.
pull-up resistor. Therefore, these pins should be con-
H
). The single-bit informa-