ALC10 KEMET [Kemet Corporation], ALC10 Datasheet - Page 7

• Manufacturer Part Number: ALC10
• Description: IEC 60384-4 Long Life Grade 40/85/56,
• Manufacturer: KEMET [Kemet Corporation]

alc10 85°c
mounting position
The capacitor can be mounted upright or
inclined to a horizontal position.
vibration
10Hz to 500Hz at 0.75mm or 10g for 3x2hrs
duration. 10Hz to 55Hz at 0.35mm or 5g
for 3x0.5hrs duration (45/50mm diameter
cans).
operational lifetime
Please see separate
notes TD003 for calculating operational
life expectancy under customer specific
conditions.
Statements of suitability for certain applications are based on our knowledge of typical operating conditions for such applications, but are not intended to constitute –
and we specifically disclaim – any warranty concerning suitability for a specific customer application or use. This Information is intended for use only by customers who
have the requisite experience and capability to determine the correct products for their application. Any technical advice inferred from this Information or otherwise
provided by us with reference to the use of our products is given gratis, and we assume no obligation or liability for the advice given or results obtained.
oPErational data
BHC
application
The failure rate is derived from our periodic
test results. The failure rate (λ
only given at test temperature for life tests.
An estimation is also given at 40°C. The
expected failure rate for this capacitor range
is based on our periodic test results for
capacitors with structural similarity. Failure
rate is frequently quoted in FIT (Failures In
Time) where 1 FIT = 1 x 10
hour.
insulating resistance
> 100 Mohms at 100V d.c., across insulating
sleeve.
voltage Proof
> 2500V d.c., across insulating sleeve.
mEchanical data
-9
R
) is therefore
failures per
rEliability
T
85°C
40°C
Failure rate per hour for catastrophic plus
parametric failures.
safety vent
A safety vent for over pressure is featured
on either the base (opposing end to the
terminals) or on the the side of the can. This
is in the form of a grooved section on the
surface of the can which is a weakened area
and is designed to relieve build up of internal
pressure due to over stress or catastrophic
failure.
a
Failure rate per hour
250 FIT
12 FIT