HD6417729 HITACHI [Hitachi Semiconductor], HD6417729 Datasheet - Page 127

• Manufacturer Part Number: HD6417729
• Description: Hitachi Microcomputer Development Environment System
• Manufacturer: HITACHI [Hitachi Semiconductor]

Description:
Table 4.3
Option
[Mode] combo box
[Emulation mode] combo box
[Step option] combo box
[UBC mode] combo box
[Memory area] group box
[AUD clock] combo box
[JTAG clock] combo box
[Driver] group box
[Change...] button
Notes: 1. When using the sequential break function, set the corresponding hardware break
2. The range of frequencies that the AUD operates under is different according to the
3. The range of frequencies that the JTAG operates at is different according to the devices
conditions.
devices used. For details, refer to section 6.5.4, Notes on Using the JTAG Clock (TCK)
and AUD Clock (AUDCK).
used. For details, refer to section 6.5.4, Notes on Using the JTAG Clock (TCK) and
AUD Clock (AUDCK).
[General] Page Options
Description
Selects the execution mode. Select Normal to perform normal
emulation. Select No Break to disable breakpoint settings.
Select Sequential break Condition 2-1, etc. to use the sequential
break function*
stops when conditions are satisfied in the order of Break
Condition 2 and Break Condition 1.)
Disables interrupts during single step execution: Interrupts during
step execution are masked.
Enables interrupts during single step execution: Interrupts during
step execution are released.
EML: The UBC is used as a Break Condition by the emulator.
USER: The UBC is released for users. In this case, the [Break
Condition] page becomes non-active.
The default is Normal. When the VP_MAP is enabled and the
address is within the table range, address translation is done
according to the VP_MAP table. For other cases, address
translation is done according to the MMU state.
Select Physical when setting with a physical address. Select
Virtual when address translation is done by the TLB table.
Selects the AUD clock*
Sets the JTAG frequency*
currently connected is changed.
Displays the device name.
Enables or disables interrupts during step execution.
Sets the address setting mode to the memory area.
Displays the driver currently selected.
Displays the [E10A Driver Details] dialog box. Use when a driver
1
. (For Sequential break Condition 2-1, execution
2
.
3
.
Rev. 2.0, 01/01, page 103 of 216