SLE ITT [ITT Industries], SLE Datasheet - Page 11
![no-image](/images/no-image-200.jpg)
SLE
Manufacturer Part Number
SLE
Description
Snap-Lock Environmentally Sealed - Rectangular
Manufacturer
ITT [ITT Industries]
Datasheet
1.SLE.pdf
(14 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
SLE-12VDC-SL-2A
Manufacturer:
松乐原装
Quantity:
20 000
Company:
Part Number:
SLE-2311
Manufacturer:
FAIRCHILD
Quantity:
76 500
Part Number:
SLE-2311
Manufacturer:
UNI
Quantity:
20 000
Part Number:
SLE0504
Manufacturer:
SLKOR/萨科微
Quantity:
20 000
Company:
Part Number:
SLE24C
Manufacturer:
ALPHA
Quantity:
50 500
Company:
Part Number:
SLE24C01D
Manufacturer:
SIEMENS
Quantity:
5 510
Part Number:
SLE24C04DP
Manufacturer:
SIEMENS/西门子
Quantity:
20 000
1. Cycle the CCT - SLE / SLC hand tool to the open
position.
4. Partially (usually the first click) Cycle the hand tool
assuring that the upward thrusting tails of the contact
has started engaging with the top jaw of the tool.
(There is a slight tendency for the contact to roll out
of vertical alignment.)
7. The result will be a perfect termination.
Snap-Lock Environmentally Sealed - Rectangular
Hand Crimp Tool Operation
Hand Crimp Tool - CCT - SLC / SLE
Part Number: 995-0002-232
The CCT-SLC/SLE hand crimp tool is designed to crimp individual SLC/SLE contacts on wire sizes 16, 18, and 20 AWG.
Each cycle is ratchet-controlled (The tool must be completely closed before it can be reopened) to assure a satisfactory
crimp each time. Over and under crimps are eliminated.
This tool is for use when the requirement is for low to moderate volume quantities, and for on-site applications where semi-
automatic tools cannot be practically used.
2. While pressing upward on the locator spring, insert
the contact with tails upward completely into the
locator.
5. Insert the pre-stripped wire into the crimp area of
the contact and completely cycle the tool.
8. Note that there are no unterminated wire strands,
and that some strand ends can be seen at the
forward edge of the crimp. Also note the insulation is
gripped by the smaller secondary crimp. Distortion is
at a minimum, both axially and laterally - no sharp
edges.
30
3. When correctly positioned the contact should be
located beyond flush with the edge of the CCT - SLE
/ SLC and positioned in the concave polished split
level crimp.
6. While pressing upward on the locator spring
withdraw the crimp termination.
Wire Stripping
Tolerance
Low
High
Specifications and dimensions subject to change
2,41 (.095)
3,30 (.130)
A
5 and 13 A Contact
Dimensions shown in mm
www.ittcannon.com
Cannon SLE
5,33 (.210)
5,59 (.220)
B