EP1K50 ALTERA [Altera Corporation], EP1K50 Datasheet - Page 11

• Manufacturer Part Number: EP1K50
• Description: 1. Enhanced Configuration Devices (EPC4, EPC8, and EPC16) Data Sheet
• Manufacturer: ALTERA [Altera Corporation]

Chapter 1: Enhanced Configuration Devices (EPC4, EPC8, and EPC16) Data Sheet
Functional Description
© December 2009 Altera Corporation
f
f
f
For configuration schematics and more information about multi-device FPP
configuration, refer to the appropriate FPGA family chapter in the
Handbook.
Passive Serial Configuration
APEX 20KC, APEX 20KE, APEX 20K, APEX II, Cyclone series, FLEX 10K, and Stratix
series devices can be configured using enhanced configuration devices in the PS
mode. This mode is similar to the FPP mode, with the exception that only one bit of
data (DATA[0]) is transmitted to the FPGA per DCLK cycle. The remaining
DATA[7..1] output pins are unused in this mode and drive low.
The configuration schematic for PS configuration of a single FPGA or single serial
chain is identical to the FPP schematic (with the exception that only DATA[0] output
from the enhanced configuration device connects to the FPGA DATA0 input pin;
remaining DATA[7..1] pins are left floating).
For configuration schematics and more information about multi-device PS
configuration, refer to the appropriate FPGA family chapter in the
Handbook.
Concurrent Configuration
Enhanced configuration devices support concurrent configuration of multiple FPGAs
(or FPGA chains) in PS mode. Concurrent configuration is when the enhanced
configuration device simultaneously outputs n bits of configuration data on the
DATA[n-1..0] pins (n = 1, 2, 4, or 8), and each DATA[] line serially configures a
different FPGA (chain). The number of concurrent serial chains is user-defined via the
Quartus II software and can be any number from 1 to 8. For example, three concurrent
chains you can select the 4-bit PS mode, and connect the least significant DATA bits to
the FPGAs or FPGA chains. Leave the most significant DATA bit (DATA[3])
unconnected. Similarly, for 5-, 6-, or 7-bit concurrent chains you can select the 8-bit PS
mode.
Figure 1–3
PS mode using an enhanced configuration device.
For specific details about configuration interface connections including pull-up
resistor values, supply voltages, and MSEL pin settings, refer to the appropriate FPGA
family chapter in the
shows the schematic for configuring multiple FPGAs concurrently in the
Configuration
Handbook.
Configuration Handbook (Complete Two-Volume Set)
Configuration
Configuration
1–11