M29W320 ST Microelectronics, M29W320 Datasheet - Page 11

• Manufacturer Part Number: M29W320
• Description: 32 Mbit 4Mb x8 or 2Mb x16 / Boot Block 3V Supply Flash Memory
• Manufacturer: ST Microelectronics

Note that if V
outermost boot block will remain protect even if RP
is at V
After a Hardware Reset, Bus Read and Bus Write
operations cannot begin until Ready/Busy be-
comes high-impedance. See Table 15 and Figure
14, Reset/Temporary Unprotect AC Characteris-
tics.
The use of an open-drain output allows the Ready/
Busy pins from several memories to be connected
to a single pull-up resistor. A Low will then indicate
that one, or more, of the memories is busy.
Byte/Word Organization Select (BYTE). The
Byte/Word Organization Select pin is used to
switch between the x8 and x16 Bus modes of the
memory. When Byte/Word Organization Select is
Low, V
High, V
ID
IL
IH
.
, the memory is in x8 mode, when it is
, the memory is in x16 mode.
PP
/WP is at V
IL
, then the 16 KByte
V
vides the power supply for all operations (Read,
Program and Erase).
The Command Interface is disabled when the V
Supply Voltage is less than the Lockout Voltage,
V
cidentally damaging the data during power up,
power down and power surges. If the Program/
Erase Controller is programming or erasing during
this time then the operation aborts and the memo-
ry contents being altered will be invalid.
A 0.1µF capacitor should be connected between
the V
pin to decouple the current surges from the power
supply. The PCB track widths must be sufficient to
carry the currents required during Program and
Erase operations, I
V
measurements.
CC
LKO
SS
Ground. V
Supply Voltage (2.7V to 3.6V). V
. This prevents Bus Write operations from ac-
CC
Supply Voltage pin and the V
SS
M29W320DT, M29W320DB
CC3
is the reference for all voltage
.
SS
CC
Ground
11/44
pro-
CC