MIC2341 MICREL [Micrel Semiconductor], MIC2341 Datasheet - Page 24

• Manufacturer Part Number: MIC2341
• Description: Dual-Slot PCI Express Hot-Plug Controller
• Manufacturer: MICREL [Micrel Semiconductor]

external 10kΩ resistor to V
Each /PWRGD[A/B] output is asserted when a slot has
been enabled and has successfully begun delivering
power to its respective +12V, +3.3V, and VAUX outputs.
The /DLY_PWRGD[A/B] outputs are asserted 164ms
after
equivalent logic diagram for /PWRGD[A/B] is shown in
Figure 8 with their corresponding state diagrams.
Micrel, Inc.
October 2007
Figure 8. State Diagrams for /PWRGD[A/B] and
its
corresponding
/DLY_PWRGD[A/B]
STBY
/PWRGD[A/B]
or a local logic supply.
output.
An
24
SYSPWRGD Digital Output
SYSPWRGD is an open-drain, asserted active-HIGH
digital output provided by the MIC2341 for additional slot
status information to the service or system processor.
This output is normally connected by an external 10kΩ
resistor to V
SYSPWRGD output for each MIC2341 and this signal
becomes activated after power-on-reset. This signal is
asserted unless at least one PCIe slot is occupied, either
ON[A/B] and/or AUXEN[A/B] of the slot in question is
asserted, either /FORCE_ON[A/B] inputs are not
asserted, and the output voltages at the load are lower
than
voltages. Functionality of the SYSPWRGD output signal
has been designed to accommodate single- and dual-
slot applications as well as applications where the
MAIN[A/B] outputs are used, but the VAUX[A/B] outputs
are not. In multiple MIC2341 applications where one or
more PCIe slots are unused and one or multiple ON[A/B]
and AUXEN[A/B] input signals are not asserted, each
SYSPWRGD
facilitating an “OR-tying” of all SYSPWRGD output
signals, thereby ensuring correct logic functionality
across the entire system.
SYSPWRGD truth table.
respective
STBY
digital
or a local logic supply. There is one
Power-is-Good
output
See Table 1 for the
will
output
appear
MIC2341/2341R
M9999-102507-A
[phone]
threshold
asserted