pe4256 Peregrine Semiconductor Inc., pe4256 Datasheet - Page 4

• Manufacturer Part Number: pe4256
• Description: 75 ? Spdt Catv Ultracmos? Switch Dc - 3.0 Ghz
• Manufacturer: Peregrine Semiconductor Inc.

Evaluation Kit
The SPDT Switch Evaluation Kit was designed to
ease customer evaluation of the PE4256 SPDT
switch. The RF common port (RFC) is connected
through a 75 transmission line to J2. Port 1 and
Port 2 are connected through 75 transmission
lines to J1 and J3. A through transmission line
connects F connectors J4 and J5. This
transmission line can be used to estimate the loss
of the PCB over the environmental conditions
being evaluated.
The board is constructed with four metal layers in
FR4 material with a total thickness of 0.062”. The
transmission lines were designed using a coplanar
waveguide with ground plane (28 mil core, 21 mil
width, 30 mil gap).
J6 provides a means for controlling DC and digital
inputs to the device. The provided jumpers short
the package pin to ground for logic low. When the
jumper is removed, the pin is pulled up to V
logic high.
When the jumper is in place, 3 µA of current will
flow through the 1 M pull-up resistor. This extra
current should not be attributed to the device.
Proper PCB design is essential for full isolation
performance. This evaluation board demonstrates
good trace and ground management for minimum
coupling and radiation.
©2005 Peregrine Semiconductor Corp. All rights reserved.
Page 4 of 8
DD
for
Figure 4. Evaluation Board Layouts
Peregrine Specification 101/0148~03A
Figure 5. Evaluation Board Schematic
Peregrine Specification 102/0195~02A
Document No. 70-0144-01 / UltraCMOS™ RFIC Solutions
Product Specification
PE4256