gl819 Genesys Logic, gl819 Datasheet - Page 8

• Manufacturer Part Number: gl819
• Description: Usb 2.0 Generation 3 Multi-i/f Card Reader Controller
• Manufacturer: Genesys Logic

CHAPTER 2 FEATURES
©2000-2007 Genesys Logic Inc. - All rights reserved.
USB specification compliance
-
-
-
Integrated USB building blocks
-
Embedded 8051 micro-controller
-
-
-
-
Support firmware upgrade to external flash via USB ( ISP : in system programming )
USB 2.0 certified (Test ID=40002675)
WHQL submission number 938163
Vista submission number 1220953
On-Chip power MOSFETs to control flash media card power.
CompactFlash
-
-
-
SmartMedia
-
-
xD-Picture Interface ( Submission ID: AA-RG0435 )
-
-
MemoryStick
-
-
-
Secure Digital
-
-
-
-
-
-
-
-
-
High efficient hardware engine
-
-
On board 12 MHz Crystal driver circuit
Available in 128-pin LQFP 14x14 mm package
Comply with 480Mbps Universal Serial Bus specification rev. 2.0.
Comply with USB Storage Class specification rev. 1.0.
Support 1 device address and up to 4 endpoints: Control (0)/ Bulk Read (1)/ Bulk Write (2)/Interrupt (3).
USB2.0 transceiver macro (UTM), Serial Interface Engine (SIE), Build-in power-on reset (POR)
and low-voltage detector (LVD)
Operate @ 60 MHz clock, 12 clocks per instruction cycle
Embedded 48K-byte mask ROM and internal 256 byte SRAM
Embedded 4K-byte external SRAM
Support up to external 48K code ROM
Support CFA specification v2.1 / v3.0
Support True IDE mode
Support 8 / 16 bit data mode and different timing
Support different page size, and automatic append redundant area data (8 / 16 bytes)
Compliant with xD-Picture specification v1.2B.
xD-Picture Type M/H card support.
Compliant with MemoryStick interface specification v1.40-00
Compliant with MemoryStick PRO interface specification v1.00-01
Support automatic CRC16 generation and verification
Compliant with Secure Digital specification v2.0
Compliant with MMC interface specification v4.2 (external flash)
Support both SD / MMC mode access CLK/CMD/DAT0/DAT1/DAT2/DAT3/DAT4/DAT5/DAT6/DAT7
Support SD specification v1.0 / v1.1 / v2.0
Support MMC specification v4.0 / v4.1 / v4.2(ext flash support) x1 / x4 / x8 data transmission.
Automatic CRC7 generation for command and CRC7 verification for response on CMD
Support automatic CRC16 generation and verification on DAT0:7
In addition to full packet transaction, optional single byte / bit operation on both CMD and DAT line / lines
Process data in block or byte
Automatic data read / write with card by hardware engine
Easier firmware development
8 bit data width and different speed
TM
TM
TM
TM
interface
/ MemoryStick PRO interface
and MultiMediaCard
interface
GL819 USB 2.0 Generation 3 Multi-I/F Card Reader Controller
TM
Page 8