RF3133PCBA-41X RFMD [RF Micro Devices], RF3133PCBA-41X Datasheet - Page 6

• Manufacturer Part Number: RF3133PCBA-41X
• Description: QUAD-BAND GSM850/GSM/DCS/PCS POWER AMP MODULE
• Manufacturer: RFMD [RF Micro Devices]

2-464
Base
Pkg
Pin
10
11
12
1
2
3
4
5
6
7
8
9
RF3133
DCS/PCS IN
TX ENABLE
GSM OUT
VCC OUT
DCS/PCS
Function
SELECT
VRAMP
GSM IN
VBATT
BAND
VREG
VCC2
VCC2
GND
OUT
Description
RF input to the DCS band. This is a 50Ω input.
Allows external control to select the GSM or DCS band with a logic high
or low. A logic low enables the GSM band whereas a logic high enables
the DCS band.
This signal enables the PA module for operation with a logic high. Once
TX Enable is asserted the RF output level will increase to -2dBm.
Power supply for the module. This should be connected to the battery.
Regulated voltage input for power control function. (2.8V nom)
Ramping signal from DAC. A simple RC filter may need to be con-
nected between the DAC output and the VRAMP input depending on
the baseband selected.
RF input to the GSM band. This is a 50Ω input.
Controlled voltage input to driver stage for GSM bands. This voltage is
part of the power control function for the module. This node must be
connected to V
RF output for the GSM band. This is a 50Ω output. The output load line
matching is contained internal to the package.
Controlled voltage output to feed V
control function for the module. It can not be connected to anything
other than V
decoupling capacitor).
RF output for the DCS band. This is a 50Ω output. The output load line
matching is contained internal to the package.
Controlled voltage input to DCS driver stage. This voltage is part of the
power control function for the module. This node must be connected to
V
CC
out.
CC2
CC
, nor can any component be placed on this node (i.e.,
out.
CC2
. This voltage is part of the power
Interface Schematic
Rev A6 050909