SC2A100KC DBLECTRO [DB Lectro Inc], SC2A100KC Datasheet - Page 9
![no-image](/images/no-image-200.jpg)
SC2A100KC
Manufacturer Part Number
SC2A100KC
Description
CHIP TYPE, LOW LEAKAGE CURRENT
Manufacturer
DBLECTRO [DB Lectro Inc]
Datasheet
1.SC2A100KC.pdf
(13 pages)
DB LECTRO Inc. 3755 Place Java, Suite 140, Brossard, Québec, J4Y 0E4, Canada - T: 1-450-444-1424 / F: 1-450-444-4714 / www.dblectro.com
3. In The Equipment
4. Maintenance and Inspection
5. In an Emergency
6. Storage
7. Disposal
1) Do not directly touch terminal by hand.
2) Do not short between terminal by conductor, nor spill conductible liquid such as alkaline or acidic
3) Please make sure that the ambient conditions where the set is installed will be free from spilling water
Please periodically inspect the aluminum capacitors that are installed in industrial equipment. The
following Items should be checked:
1) If you see smoke due to operation of safety vent, turn off the main switch or pull out the plug from the
2) Do not draw your face to the safety vent since gas over 100 C will be emitted when the safety vent
1) Do not keep capacitor in high temperature and high humidity.
2) Avoid ambient conditions where capacitors can be covered with water, brine or oil.
3) Avoid ambient conditions where capacitors are exposed to poisonous gases such as hydrogen sulfide,
4) Do not keep capacitor in conditions that expose the capacitor to ozone, ultraviolet ray or radiation.
Please dispose capacitors in either of the following ways:
1) Incinerate capacitors after crushing parts or making a hole on the capacitor body.
2) Bury capacitors in the ground. Please have a disposal specialist do it.
solution on or near the capacitor.
or oil, direct sunlight, ultraviolet rays, radiation, poisonous gases, vibration or mechanical shock.
outlet.
operates. If the gas has entered your eyes, please flush your eyes immediately in pure water. If you
breathed the gas immediately wash out your mouth and throat with water. Do not ingest electrolyte. If
your skin is exposed to electrolyte, please wash it away using soap and water.
Storage conditions should be:
sulfurous acid, nitrous acid, chlorine, ammonium etc.
Appearance: Remarkable abnormality such as vent operation, leaking electrolyte etc.
Electrical characteristic: Capacitance, dielectric loss tangent, leakage current etc., which are specified
in this catalogue.
Cleaning condition: Total cleaning time shall be within 5 minutes by immersion, ultrasonic or other
environment. Please consult us regarding other cleaning agents or cleaning methods.
Temperature : +5 C ~ +35 C
Humidity
Place
Avoid using ozone destructive substance for cleaning agents to concern about global
: Lower than 75%
: Indoor
method. Temperature of the cleaning agent shall be 60 C or lower. After
cleaning, capacitors should be dried using hot air for minimum of 10 minutes
along with the PC board. Hot air temperature should be below the maximum
operating temperature of the capacitor. Insufficient dry after water rinse may
cause appearance problems, sleeve shirk, bottom- plate bulge and such.