ilx554 Sony Electronics, ilx554 Datasheet - Page 11

• Manufacturer Part Number: ilx554
• Description: 2048-pixel Ccd Linear Sensor B/w For Single 5v Power Supply Bar-code Reader
• Manufacturer: Sony Electronics

Notes on Handling
1) Static charge prevention
2) Notes on handling CCD Cer-DIP package
3) Soldering
CCD image sensors are easily damaged by static discharge. Before handling, be sure to take the following
protective measures.
a) Either handle bare handed or use non-chargeable gloves, clothes or material. Also use conductive
b) When handling directly use an eath band.
c) Install a conductive mat on the floor or working table to prevent the generation of static electricity.
d) lonized air is recommended for discharge when handling CCD image sensors.
e) For the shipment of mounted substrates use cartons treated for the prevention of static charges.
The following points should be observed when handling and installing this package.
a) (1) Compressive strength: 39N/surface
b) In addition, if a load is applied to the entire surface by a hard component, bending stress may be
c) Be aware that any of the following can cause the glass to crack because the upper and lower ceramic
a) Make sure the package temperature does not exceed 80°C.
b) Solder dipping in a mounting furnace causes demage to the glass abd other defects. Use a grounded
c) To dismount image sensors, do not use a solder suction equipment. When using an electric desoldering
Upper ceramic layer
Lower ceramic layer
shoes.
(2) Shearing strength:
(3) Tensile strength:
(4) Torsional strength:
generated and the package may fracture, etc., depending on the flatness of the ceramic portion.
Therefore, for installation, either use an elastic load, such as a spring plate, or an adhesive.
layers are shielded by low-melting glass.
(1) Applying repetitive bending stress to the external leads.
(2) Applying heat to the external leads for an extended period of time with a soldering iron.
(3) Rapid cooling or heating.
(4) Applying a load or impact to a limited portion of the low-melting glass with a small-tipped tool such
(5) Prying the upper or lower ceramic layers away at a support point of the low-melting glass.
Note that the preceding notes should also be observed when removing a component from a board after
it has already been soldered.
30W soldering iron and solder each pin in less than 2 seconds. For repairs and remount, cool
sufficiently.
tool, ground the controller. For the control system, use a zero cross type.
(Do not apply any load more than 0.7mm inside the outer perimeter of the glass portion.)
as tweezers.
39N
(1)
Low-melting glass
29N/surface
29N/surface
0.9Nm
29N
(2)
– 11 –
29N
(3)
0.9Nm
(4)
ILX554A