H HiTRON
AC/DC EXTERNAL WALLMOUNT ADAPTER USA OR
EUROPEAN INPUT SINGLE OUTPUT 16-18 WATTS
SWITCHING POWER SUPPLIES HES16B & HES16C SERIES
Due to requests in market and advances in technology, specifications subject to change without notice.
NOTE:(1) All measurements are at nominal input, full load, and +25°C. unless otherwise specified.
GENERAL SPECIFICATION
Efficiency: 80% typical.
Switching Frequency: 65-75K Hz.@ full load typical.
Circuit Topology: Free-running flyback circuit.
Transient Response: Output voltage returns typ. 6mS.
Safety Standard: UL1950/EN60950. Class I or II.
Power Density: 1.45 Watts / Cubic inch.
SPECIFICATION
INPUT SPECIFICATION
Input Voltage: HES16B typical 90-132Vac,rating 120Vac.
Input Connector: Wallmount Format.
Input Frequency: 47-63Hz.
Inrush Current: HES16B: 18.0A @ 115Vac typical.
Input Current: HES16B 0.234A @ 115Vac typical.
Dielectric Withstand: Meet IEC60950.
EMI: Meet EN 55022 or FCC Class B.
Hold-up Time: 27.6mS@115Vac/53.6mS@230Vac typical.
HES16B:WM1(U.S.2-blade)/WM2(U.S.3-blade).
HES16C:WM3(Euro-stecker)/WM4(Schuko-stecker)/
HES16C: 28.0A @ 230Vac typical. (by thermister)
(2) Load regulation is measured at 230Vac or 120Vac in percentage to indicate the change in output voltage as the load varied from half load to full load (±%).
(3) The exact obtainable load regulation depends upon the output cord selected and load current. Upper data are for 6 ft. (2 m) cord AWG#18 wires.
WM5(UK)/WM5G(UK)/WM6,6G(Australia).
HES16C typical180-264Vac,rating 230Vac.
HES16C 0.133A @ 230Vac typical.
following a 25% load change.
-21-
FEATURES:
OUTPUT SPECIFICATION
Output Voltage: See Ratings Chart.
Output Current: See Ratings Chart.
Output Wattage: 16-18 Watts typical.
Output Connector: Optional.
Line Regulation: 0.65% typical.
Load Regulation: ±1.5% typical.
Noise & Ripple: 1.0% typical peak to peak.
OVP: Built-in, By Zener diode clamping.
Adjustability: Factory set.
Overload Protection (OLP):
Operating Temperature: 0 to +40°C with no derating.
Storage Temperature: -20 to +85°C.
Temperature Coefficient: 0.04% /°C typical.
Cooling: Free air convection.
Construction: Impact resistant thermo-plastic
Wallmount format.
Fully protected against output overload and short circuit.
OLP set at about 120-150% max. load.
Consult the factory for special OLP setting.
LOW COST WALLMOUNT ADAPTER
DIVERSE AC PLUGS AVAILABLE
MEET DIVERSE SAFETY STANDARDS
EMI MEET EN 55022 OR FCC CLASS B
CE MARKING COMPLIANCE
For the details of safety approval, please consult the factory.
enclosure case.